It means that the "Resistance of the Conductor varies directly with the temperature between a range or up to a limit". Varies Directly Means : If one increases the other too increases and vice versa.
No, lemon is not a good conductor of electricity. It has a high resistance to electrical current due to its low water content and lack of metallic properties.
When current is passed through the wire, the negatively charged electrons (Current) face resistance as the molecules of the conductor block their way. These moving electrons collide with the molecules of the conductor and heat is produced which heats up the metallic wire.
A glass bottle is an insulator, meaning it does not conduct electricity easily. Glass is a non-metallic material that has high electrical resistance, making it a poor conductor of electricity.
Glass microscope slides are considered insulators because they do not conduct electricity. They are typically made of non-metallic materials such as glass, which have high electrical resistance and do not allow the flow of electric current.
No, dry wood is not a good conductor of electricity as it has high resistance. This is because it contains very few free ions or electrons to carry electric current. Wet wood, on the other hand, can conduct electricity better due to the presence of moisture.
An increase in current will only affect resistance if it causes the temperature of the conductor to change. For pure metallic conductors, and increase in temperature will cause an increase in resistance.
In general, pure metal conductors increase in resistance as their temperature increases. This is not necessarily true for alloys, as some alloys are manufactured to have an approximately constant resistance over a wide range of temperatures.
The resistance of pure metallic conductors increases with temperature, because the resistivity of these conductors increase with temperature.
it is malleable, a good conductor of electricity forgot solid at room temperature
No, lemon is not a good conductor of electricity. It has a high resistance to electrical current due to its low water content and lack of metallic properties.
When current is passed through the wire, the negatively charged electrons (Current) face resistance as the molecules of the conductor block their way. These moving electrons collide with the molecules of the conductor and heat is produced which heats up the metallic wire.
That is the resistance, measured in ohms.
It depends on whether the material is ohmic or non-ohmic.If it is ohmic, then it will obey Ohm's Law, and its resistance will remain constant if the current decreases.If, on the other hand, it is non-ohmic, it will not obey Ohm's Law and, if the temperature of the conductor falls (assuming it is a metallic conductor) due to the fall in current, then its resistance will fall too.
If the current through a pure metallic conductor causes the temperature of that conductor to rise, then its resistance will increase. A practical example of this is an electric lamp. The cold resistance of a lamp is very much lower than the hot resistance.
A glass bottle is an insulator, meaning it does not conduct electricity easily. Glass is a non-metallic material that has high electrical resistance, making it a poor conductor of electricity.
high melting and boiling point, good conductor of electricity and heat, solid at room temperature (except mercury)
The mechanism of metallic resistance : as temperature increases the thermal vibrations in the lattice increase causing more electron scattering therefore more collisions will take place, slowing down the electron flow. This increases the rate of transfer of electrical energy by heating and increases the electrical resistance. The semiconductor's electrons also vibrate more at higher temperature so this contributes to resistance increase in the same way as for a metal. So what else could make the semiconductor conduct better? The answer is: more charge carriers. Whereas the number of free electrons in a metal is constant the effect of heating a semiconductor frees additional electrons (and holes). For silicon in this temperature range the effect of additional charge carriers outweighs the effect of additional vibrations, so the overall resistance will decrease with temperature.