0
1- Education and Commitment: Let people know why the change is needed and what it is to achieve, what will their future status be? and how this change can be accomplished.
2- Participation and Involvement: Have people involved in the creation of the change.
3- Facilitation and Support: Prepare people for their new tasks, and show them that you are supportive (given the fact change makes people stressed).
4- Negotiation and Agreement: Allow people to voice their concerns and to comment. and welcome the resistance as a result of concerns not as opposition.
5- Manipulation and Cooptation: have change resistance leaders involved symbolically in the change by giving them symbolic roles that doesn't allow them to effect the change progress. However, this method is a two edged sowed, if the change resistance leader figure out that you trick him, he might be come more resistant to the change than before!
6- Implicit and Explicit Coercion: This method is used in case a quick change was needed and is to be accepted immediately! Managers can make clear that resisting change will result in job losses, salary cuts, and other kinds of punishment.
Abdul
What else can I help you with?
What is the equivalent resistance of a pair of 4 ohms resistor in parallel?
Four 4 ohm resistors in parallel have an equivalent resistance of 1 ohm. Two resistors R1 and R2 in parallel have an equivalant resistance of R1R2/(R1+R2). Plug in 4 ohms for two of the resistors and you get 2 ohms. Repeat and you get 1 ohm.
Which lever would have more mechanical advantage than one with a resistance arm of 3 riches and an effort arm of 6 inches?
A lever with a resistance arm of 3 inches and an effort arm of 1 inch would have more mechanical advantage as the effort arm is shorter than the resistance arm, making it easier to lift the load.
Math Problems with solutions about series and parallel circuit?
I have two resistors, a 2-ohm and a 3-ohm.What is their combined effective resistance when they are connected in series ?Answer: R1 + R2 = 5 ohmsWhat is it when they are connected in parallel ?Answer: 1 / [ (1/R1) + (1/R2) ] = 1.2 ohms
A 120 ohm resistor a 60 ohm resistor and a 40 ohm resistor are connected in parallel to a 120 volt power source. What is the current running through the entire circuit?
6
Car is traveling at a constant speed of 12 m s when the driver accelarates the car reaches a speed of 26 m s in 6 s what is the average accelaration of the car?
The change in velocity is 26 m/s - 12 m/s = 14 m/s. The time taken for this change is 6 seconds. Therefore, the average acceleration is (change in velocity / time) = 14 m/s / 6 s = 2.33 m/s^2.
What are the release dates for Independent Sources - 2008 Dealing with the Detained 6-17?
Independent Sources - 2008 Dealing with the Detained 6-17 was released on: USA: 8 January 2014
What is the ISBN of Expect Resistance?
The ISBN of Expect Resistance is 0-9709101-6-9.
What are the release dates for Battlestar Galactica The Resistance - 2006 Webisode 6 1-6?
Battlestar Galactica The Resistance - 2006 Webisode 6 1-6 was released on: USA: 21 September 2006
What are the release dates for Come Home to Life - 2007 Dealing with Disappointment 1-6?
Come Home to Life - 2007 Dealing with Disappointment 1-6 was released on: USA: 14 August 2007
What are the release dates for Bite Me - 2010 Resistance 2-6?
Bite Me - 2010 Resistance 2-6 was released on: USA: 12 April 2012
What are the ratings and certificates for Nikita - 2010 Resistance 1-6?
Nikita - 2010 Resistance 1-6 is rated/received certificates of: Netherlands:12
If the resistance of a resistor is 6 ohms what is the conductance?
(1/6) ohm-1
How many mA in total when four AA batteries of 1.5 volt is combined?
depending on your load resistance what are you using . suppose you are using 100 ohm load resistance than current will flow 1.5*4=6/100=0.06Amp and if you are looking for battery current capacity than mind it you are using series connection the current will not change remain same as one battery but voltage will change as i mention above 6 volt.
What are the methods of credit control?
1.bank rate policy 2.open market operation 3.change in reserve ratio 4.change in margin requirement 5.moral suasion 6.selective credit control
What are the release dates for Conan - 2010 The Fast and the Dealing-With-Their-Fury-Through-Journaling 6 3-100?
Conan - 2010 The Fast and the Dealing-With-Their-Fury-Through-Journaling 6 3-100 was released on: USA: 13 June 2013
If the volts going in equals 5 and there is a resistance that equals 6 what would be the volts coming out?
The question is a bit ambiguous, but I will try to address it. If the 6 ohm resistance is in series with another resistance then some of the 5 volts would be dropped across the 6 ohm resistance and the remainder of the voltage would be dropped across the other resistance. To calculate the voltage, use the 'resistor voltage divider equation' (Google it). If the 5 volts is applied across only a 6 ohm resistance, then the top of the resistor is at 5 volts and the bottom of the resistor would be at 0 volts. The resistor would drop all of the voltage.
How do you calculate the voltage in a circuit with a resistance of 20hms and a currents of 6?
Use Ohm's Law. In this case, multiply the resistance by the current.
