in bunsen burner complete combustion takes place,it produces blue flame and blue region is the hottest part of a flame.so the whole flame is very hot,either the outermost part of flame.
The hottest part of the flame on a Bunsen burner is at the tip of the inner blue cone. This part of the flame is where combustion is most complete, resulting in the highest temperature.
A Bunsen burner flame is at its hottest when it is blue with a sharp inner cone. This is because the blue part of the flame has the most complete combustion of fuel, creating a higher temperature compared to the lower, yellow part of the flame.
The two energy regions in a Bunsen burner are the inner blue cone, which is the hottest part of the flame and is where combustion occurs, and the outer yellow flame, which is cooler and is responsible for creating a visible flame.
by having 4 iron wires and placing each one of them in different parts of the flame observe the wire then record results not what wire is placed at what part of the bunsen then see which one is the most red (the more red the more hot the area of the flame you have out it on for it to be a fair test you should have the bunsen on a yellow/orange flame and hover the wire with tongs at the different areas do not change to a blue flame for a different wire,this was out of common sense but i dont know if my theory is correct
A properly adjusted nonluminous flame on a Bunsen burner has two distinct cones: the inner blue cone, which is the hottest part where complete combustion occurs, and the outer yellow cone, which is where incomplete combustion occurs.
The hottest part of a Bunsen flame is the blue inner cone.
Near the tip of a blue flame is the hottest.
The hottest part of the flame on a Bunsen burner is at the tip of the inner blue cone. This part of the flame is where combustion is most complete, resulting in the highest temperature.
The inner blue part of the flame is the hottest on a Bunsen burner, as this is where complete combustion occurs due to the optimal air-to-gas ratio.
The hottest part is where the flame is light blue or blue; which gradually turns to yellow as the flame is cooled by the colder outer air. When the safety flame (yellow) is on, the hottest point is the tip of this flame.
The tip of the blue cone is the hottest part of the Bunsen burner flame.
the 'roaring' flame - which is the one when the oxygen valve is open.
The white part of a flame on a Bunsen burner is called the inner cone. This part of the flame is the hottest and is where complete combustion of the fuel is occurring.
The blue part of the flame, the cone in the middle is the hottest, the flame cools as it gets further away from the burning centre, this is similar to the sun where the outer surface of the sun is significantly cooler compared to the inside.
The inner blue cone of the flame in a Bunsen burner is the hottest part, as it has the highest temperature and most complete combustion. This part of the flame is where the flame is the most efficient for heating purposes.
the hottist part is the rouring flame and the light blue bit inside is the hottist the top of it
The blue flame of a Bunsen burner is the hottest part of the flame, making it ideal for heating and sterilizing purposes in a laboratory setting. The blue flame indicates complete combustion of the gas, leading to a cleaner and more efficient burn.