You shouldn't - it's purpose is to keep the RF noise away.
Phantom power is typically required for condenser microphones to operate. To use them, make sure your audio interface or mixer provides phantom power, then connect the microphone using an XLR cable. Turn on the phantom power before using the microphone, and remember to turn it off when finished to avoid potential damage to the mic.
Basic equipment 1.Cd players / turntables 2.Mixer 3.Speakers (Active - not needing a amp or Passive - Needing a powered amp) 4.Amp (If needed) 5.Headphones 6.Microphone 7.Wiring a) phono leads - red and white wires from CD player to mixer b)Xlr - from the mixer to the amp or speakers c)Speakon leads - from the amp to the speakers and not forgetting..... 8.Music!
XLR refers, not to the cable (wire) per se, but actually to the type of connector used. An XLR connector has 3-pins and is used primarily in audio. Professional microphones and other audio equipment use it. Of the three pins, two are for the balanced signal, and one is for the shield. The wire used then is a two conductor shielded cable using a braided wire or a foil shield. So, an "XLR cable" refers to a two conductor, shielded cable with XLR connectors on each end.
Search for XLR splitter
Yes, the XLR connector can be rotated and locked into position
It is a XLR microphone connector that has holes instead of pins
A XLR connector is an electrical connector used for audio, video, and stage lighting equipment. The come in a circular design with anywhere between three and seven pins.
Pin 1 = ground/shield, Pin 2 = hot/plus, Pin 3 = cold/minus
In the manual
XLR has a locking mechanism on it, can't short itself and is more robust connector in general.
The XLR connectors that are found on lighting equipment are a half circle, with 3 prongs on the male connector, and 3 holes for prongs on the female connector.
XLR
Connector and impedance
Male XLR connectors have pins or prongs that plug into a female XLR connector, which have corresponding holes or slots to receive the pins. Male connectors are typically used on microphone cables, while female connectors are found on audio equipment like mixers and amplifiers.