0
What else can I help you with?
How do you remove the distributor on an EA falcon?
To remove the distributor on an EA Falcon, first remove the distributor cap. Use an extension bar to reach and remove the small lug that holds the distributor.
How do you change the distributor on a Ford truck?
Rotate engine to TDC Intake Stroke Remove Distributor cap Remove vacuum line to vacuum advance if equipped Remove horsehoe type clamp on side of distributor Lift out distributor
Do you have to remove the distributor to replace the stator in a 90 Chevy 350?
Yes you do. You have to take the distributor shaft out of the distributor to Remove the pick-up coil / stator.
How do you take the distributor off of a 1991 blazer 350 5.7liter?
you remove the wires that are going to the distributor and look where the distributor meets the intake there is a little plate the rests against the distributor and it has a bolt in it remove that and pull distributor up and out and u have to remove wires that go to the plugs as well
How do you remove a distributor cap from a 1986 Chevrolet celebrity?
On the 2.8L V6 the distributor cap is held on with two screws. Unscrew the two screws and pull straight up on the distributor cap to remove it from the distributor.
How do you remove the distributor cap and rotor on a 1994 Nissan Sentra?
how do you remove a distributor rotor on a 92 Nissan sentra
How do you remove the rotor from a 1996 ford bronco 4x4?
If you mean the rotor from inside the distributor. Just unclip the 2 clips and lift up the distributor cap then use a nut driver to remove the 2 bolts on the rotor.
How do i remove distributor cap that has strip screw heads?
Remove and mark wires Break with a hammer Use vise grips to remove screws Replace with new one
How do you remove 1968 vw beetle distributor?
First unhook the battery. Next, remove the distributor cap and unhook the wire that runs to the coil. Then loosen the distributor clamp (10mm nut) and pull the distributor out.
How do to remove a distribuitor on a 89 GMC Surburban?
Bring the #1 cylinder up to top dead center, remove the distributor cap, mark where the rotor is pointing on the distributor body, loosen or remove the distributor hold down and pull the distributor straight up.
How do you disassemble the internal portion of a 94 Acura Vigor distributor?
Pull the battery and the battery heat shield and unplug the coil and sparkplug wires from the distributor cap. Remove the two 8mm bolts that hold the distributor to the head (12 mm wrench.) Remove the distributor, there are no wires attached to it. Remove the distributor cap and then remove the piece on the bottom of the the distributor that has an 'o' ring. The piece is just held in the distributor body by another 'o' ring that you cannot see until the piece is pulled out. Use a pliers or you might be able to remove it by hand. Then remove the snap ring from the distributor shaft. You can do it with a pick or a small nail as it is not very strong. Then push the pin out of the shaft and you can take the thing apart. There are three screws on the top side that might require removal, I'm not sure.
How do you replace the distributor cap on a 1996 Chevy Astro van?
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.
