make sure that trans is in N if that dont work turn car off then shift to 2wd or 4wd
4L is the low gear in 4WD, 4H is the high gear. Most of the time, 4L is all you'll need to get out when stuck.
need more info.. is it a manual 4WD that you have to pull the lever on the transmission hump to engage the 4wd or is it push button 4WD?
Shifting from 4H to 4L (and 4L to 4H) 1. Bring the vehicle to a stop. 2. Depress the brake. 3. Place the gearshift in N (Neutral). 4. Move the 4WD control to the 4H (or 4L) position. Shifting from A4WD to 4H Move the 4WD control from A4WD to 4H at any forward speed. Shifting from 2H to 4H can be done at speeds up to 88 km (55 mph).
The blazer could have trouble with the shift switch. The shift solenoid could be defective as well. Check both of these for problems.
IF the system is working correctly, just put the gearshift in Neutral. Press hard on the brake, and turn the switch to 4H or 2WD. The Ranger and most other 4WD's will shift on the fly (in Drive) to 4H (4-wheel High), but require the gearshift to be in Neutral in order to shift out of 4L (4-wheel Low).
To engage the 4WD in a 2005 Jeep Grand Cherokee Laredo, locate the 4WD control switch on the center console. Depending on your model, you may have a part-time or full-time transfer case. Shift the transmission into neutral, then turn the 4WD switch to the desired mode (such as 4H for high-range or 4L for low-range) and ensure the indicator light on the dashboard confirms the selection. Once engaged, shift the transmission back into gear to drive.
I believe you will still have to shift the truck into 4wd inside the cab after locking the hubs on the wheels...I can't remember what year my Dad's F-150 was but he had to lock the hubs on the wheels first then shift the manual shifter inside the truck into 4wd to engage the 4wd feature. If there isn't a manual shift inside the cab, I give!
The shift pattern for the transfer case on a 1989 Jeep Wrangler typically includes options for 2WD, 4WD High (4H), and 4WD Low (4L). The transfer case lever is usually shifted from 2H to 4H while the vehicle is in motion at low speeds, and 4L is engaged when the vehicle is stopped or moving very slowly. The exact configuration may vary slightly based on whether the Wrangler is equipped with the NP231 or NP205 transfer case. Always refer to the owner's manual for specific instructions and recommendations.
its on a 98 dodge ram with a manual shifter shifts fine but dose not engage
First, make sure it has 4wd available. Second, check to see if you have to be in gear to shift into 4wd. Some vehicles must be driving to switch. They may also have limits, like driving below 30km/h. Finally, it may be worn or rusted so that the second differential does not engage.
Great Question! I hope someone answers you because I have the same issue - my 4wd works but the light blinks and I want to know why!