The anti-pollution fault light on a Peugeot 406 is an indication that something is wrong with the smog prevention part of the engine. This could be as simple as the replacement of the air filter or as costly as replacing the oxygen sensor on the vehicle. Either way, it should be investigated before the engine quits.
most probabably particular filter fault. there should be a tank beside your fuel tank that takes an additive that is sprayed into the filter. Get it checked as the filter is about £600+ The additive is about £30 ! Do the maths ;)
By fixing the fault that has caused the light to come on. Simpels.
That is ECU fault warning light, take it for diagnostics to find the exact fault
This symbol is the engine management light. It means that there is a fault somewhere on the car, a written warning of the fault will then usually flah up where you digital clock dial is.
This could possibly be the engine management light if so it means the system has detected a fault. The car needs to be connected to diagnostic equipment for fault diagnosis and the light to be re set.
it is the engine managment light indecating a fault
I have a 307 1.4 petrol 04 plate Peugeot. Last night I got a "Anti pollution fault" display. The way I rectified this was: 1) I sometimes let the orange light come on my fuel - DON'T do this! Always make sure there is sufficient fuel in you car. I topped the fuel up and the fault light went off. 2) I topped up the tank with some Reddex Fuel Cleaning fluid 3) I then took the car for a 30 min drive down the motorway travelling at approx 60 mph for the duration. This seemed to make the vehicle less sluggish and run more smoothly. This may not work for everyone but it's certainly worth a try ;-)
its the engine diagnostics warning light which tell you have a fault following a audio signal and visual signal saying some kind of fault. its the engine diagnostics warning light which tell you have a fault following a audio signal and visual signal saying some kind of fault.
reconnect the plug under driver seat. it helps.
Plug a laptop or code reader into the diagnostics socket, find out what the fault is, or was, clear the fault if it's still on or cancel the alarm thereby turning out the fault light if it's just a transitory fault which has already cleared. If you're in the AA or RAC, call 'em out to do it.
engine fault/oil low/water low .brake fault