Area

• If the circle's diameter is two miles, the area would be: 8042 acres
• A diameter radius of two miles is 12.5 square miles
• If the circle's circumference is two miles, the area would be: 203.7 ac

Multiply the two dimensions to get the area. The calculation will give you 1,280 square feet.

16 square yards. Carpeting is sold by the square yard.

To find total area ,

125 acres X 150 acres = 18750 acres

8 feet by 4 feet = 32 square feet.

1 square foot = 0.09290304 square metres.

32 square feet = 2.9728973 square metres.

306 square feet. Multiply length by width - the result is the area in square feet.

One acre is equal to 43,560 square feet.

0.625

1 Kuli = 151.25 sq. ft.

1 Larcham = 18 Kulis = 2722.5 sq. ft.

1 Acre = 16 Larchams = 288 Kulis = 43560 sq. ft

Meters squared (m2) and square meters (m2) are exactly the same.

Therefore, 10 000 m2 is the same as 10 000 square meters.

15 by 62 equal 930 ft2

(one foot 2 inches) or you can say 1'2" or say 1ft 2in.

There are 132 square feet in a room that is 11 feet by 12 feet. This can be calculated by multiplying the length (11 feet) by the width (12 feet).

The majority of Kenya's population is black African. There are also small numbers of Asians, Europeans, and Arabs. The black Africans are divided into more than 30 ethnic groups, with the largest being the Bantu-speaking Kikuyu, Luhya, and Kamba, the Nilotic-speaking Luo, and the Paranilotic-speaking Kalenjin. A 1995 estimation of Kenya's population was 27,885,000. The overall population density is about 48 people per square kilometer. At the time of this estimate, the population was increasing at a rate of 3.2 percent annually, among the fastest rates in the world.

Kenya has a population of 38.7 million, according to the results from the 2010 census.

10 ft by 27 ft = 10 ft x 27 ft

= 270 sq ft

Answer: 25 m² = 269.097 ft²
269.1 square feet.

There are approximately 322917 square feet in 30000 square meters.

According to the reference given below referring to the land measuring unit Gunta, in Pakistan, 1 anna = 20.16 sq yd. Since 1 square yard is 3*3=9 square feet, 1 anna is 20.16*9=181.44 square feet.

To determine the square meters in 750 lineal meters, we need the width of the area. If you provide the width in meters, we can calculate the square meters by multiplying the width by the length (750 meters).

13 feet = 156 inches or 396.24 cm or 3.9624 m.

14 feet = 168 inches or 426.72 cm or 4.2672 m.

This many decimal places are really redundant, because the original numbers were accurate only to the nearest foot. So if we multiply the two lengths in meters and round off to a tenth of a square meter, we get 16.9.

A room that is 12 feet by 27 feet has an area of 324 square feet. You can find this by multiplying the length (12 feet) by the width (27 feet).

Where I am, concrete would be made in the proportions of 1 of cement, 2 of sand, and 4 of gravel. River gravel, by definition is stronger material than the fines and sand, for it has better withstood the travel down the river. Thus river gravel will always make a stronger concrete that material quarried from a hillside, even if nominally the same rock type.

The cement should cover every material surface inside the concrete. That is why too much sand (with its proportionately higher surface to volume ratio) will weaken the concrete.

The setting reaction is a complex set of calcium carbonate, sulphate, and silicate reactions which take considerable time to form the crystals which give the strength to the concrete. And, of course, any water surplus to the crystal formation will leave (minute) voids that will give a weaker concrete.

So for concrete constructions in which strength is vital (bridges, slabs) a long drying period is preferred, and the concrete should be kept moist for as long as possible.

The cost of a cubic yard of asphalt can vary depending on location, quality, and quantity purchased. On average, the cost ranges from $100 to $150 per cubic yard, but it's best to get quotes from local suppliers for more accurate pricing.

There's no way to convert an area into a length.

You have to multiply the two dimensions to get the area. In this case the answer will be 120 square feet.