Backhoes

restricted return fluid

Shipping weight of 60s 580 CK Backhoes are approximateley 4990kg depending on whether it has cab or not. Subtract approximately 100kg for cab.

to his hand, Mrs Palmer

In order to remove a stuck transmission filter from a case sl series 2 backhoe consult with an individual at one of the auto shops. The owner's manual will also provide the information needed to make this repair.

It depends on the trans. If it is an earlier 580k then it has a wet brakek and will need specific fluid. Hytran ultra or Case transaxle fluid if newer then gear oil will suffice.

Look on the valve cover.

The fuel (typically diesel), coolant, hub oil, lubricating grease, transmission fluid, hydraulic oil. If it has an AC system, you could count the AC refrigerant, as well.

You can find information on a 758 backhoe fitted to a Ford 1900 tractor through the manufacturer's manuals, which often include specifications and operational details. Online forums and communities dedicated to vintage tractors or construction equipment may also have valuable insights and user experiences. Additionally, websites like eBay or machinery sales platforms might have listings that include specifications or attachments for similar models. Finally, local dealerships or repair shops specializing in agricultural equipment could provide helpful information and support.

What year is serial number JAB0139091

15,763 pounds

The 1971 Case backhoe model 580CK typically uses Case MS-1204 or equivalent hydraulic/transmission fluid. It's important to check the owner's manual or consult with a Case dealer to ensure compatibility, as specific fluid requirements can vary based on the machine's condition and any modifications. Always use fluids that meet the manufacturer's specifications for optimal performance.

If engine power then check the anaroid valve on the injection pump.

For a John Deere 310E backhoe, you should use John Deere Hy-Gard or an equivalent hydraulic fluid for the rear axle. The recommended viscosity is typically ISO 46. Always refer to the operator's manual or consult a John Deere dealer for the most accurate and specific fluid recommendations.

I tried to paste but unable due to being in pdf files, just google timing specs for john deere 310 and it should guide you to the pdf

On a console to the side of the driver

Depends on what is wrong. First step is to disassemble the cylinder..if the leak is small (seepage) then you can typically rebuild it with kits availible online for less than 100 bucks and a few hours. If a kit you order does not come with instructions, you can usually find disassembly/install instructions on the web. Unless the shaft is bent or excessively pitted, this is the cheapest and easiest way to repair it.

I have a 1986 Ford 550 backhoe and the transmission uses hydralic oil

my 86 580 super e uses one gallon an hour if im running hard.

Depends on which machine, I drove many and do remember they all had an easily accessible hydraulic tank.

To bleed the brakes on a John Deere 310B backhoe loader, start by raising the rear wheels off the ground and securing the machine. Locate the brake bleeder valves, typically found on each wheel cylinder, and use a wrench to open them slightly. Have an assistant pump the brake pedal several times and hold it down, then open the bleeder valve to release trapped air and brake fluid until you see a steady stream of fluid without bubbles. Close the valve, repeat for each wheel, and ensure the brake fluid reservoir is filled to the proper level throughout the process.

the wb 150 engine is built by yanmar

hitachi ex200-2gerakannya lambat, kalau jalan tersendat-sendat dan mesin panas