BMW

my dear how many cows and milk producing animal in Anand Amul dairy Gujrat.. how they are catering the demand around the globe.

no

Unlocking the doors also unlocks the fuel cap door. Just push on the hinged side of the door (or pull on the non-hinged side) and it will open right up.

You shouldn't have to unless you bought aftermarket pads that don't have a location for the wear sensor, but even in that case you wouldn't need the senor so...no. The only time when you need to change the sensor is when your brake light came on on the dash, hence the sensor has been used and is now ruined. Under these conditions, yes you should replace them. It might be possible to either clip the wire close to the end and tie the two wires together if you just want to get rid of the light on your dash, but this is slightly danagerous if your selling the vehicle to someone else. -Brake Engineer You shouldn't have to unless you bought aftermarket pads that don't have a location for the wear sensor, but even in that case you wouldn't need the senor so...no. The only time when you need to change the sensor is when you brake light came on on the dash, hence the sensor has been used and is now ruined. Under these conditions, yes you should replace them. It might be possible to either clip the wire close to the end and tie the two wires together if you just want to get rid of the light on your dash, but this is slightly danagerous if your selling the vehicle to someone else. -Brake Engineer

Possible damaged sensor or wiring to the sensor. The pad sensor is located in the brake pads themselves and changing tires will not affect them unless damaged by tire changer

I did a lot of searching on this topic since I have this problem on a 2005 325 XI.

Seems it's a poor design with a weak spring from the factory. Dealer replace well over $250. One guy replaced all 5 in his car himself and had the same problem afterwards.

One guy fixed his but extending it all the way and washing thoroughly with light detergent and hot water. Spray upholstery cleaner might work if you rinse it well and dry it. He used a vice grip to hold it in the extended position for cleaning and drying. The pot of water the one guy used was pretty filthy so they do collect dirt, dust, and sweat over time.

This should "improve" it and I'll be trying that tonight.

Good luck

A Porcupine has pricks on the outside :) If the BMW rolls over, you can usually find plenty of people willing to help you roll it back over.

the very first BMW was made in German. all bmws were made in German

yes

In 1916

with your left foot!!!!!!!!!!!!!!!!!!!!!!!

Executive Sedan

yes they will that's what I have on mine I bought it used and that's how it came

no!! you cant...... my uncle owns a rim shop, and i ask the same question ..and he said no .. because BMW has its own design

disconnect the negative battery terminal for 10 minutes.

What is the value of a 1988 BMW 535is

under the section 'The resource based view of the firm', we discuss of the notion of strategic asset.

In the case of BMW cars, do some research and discuss of the strategic assets of BMW company.

verry carfully

4x100, forget the hub diameter but can use wheels from the e30 (non-m3) and old vw golf/jetta/scirocco etc.

use the button insode the drivers door

155MPH / 0-60MPH in real life approx 4.9 seconds

you might of got water on the alternater It also might be a short in the ignition system.

Bayerische Motoren Werke or BMW is a lucrative car company with a simple stock ticker symbol. Their current stock ticker symbol is BMW

fast?! too fast!!!!!!

i have just removed one on a 1992 318i, it may be the same. carefully pry out BMW badge from steering wheel (i used 2 small jewellers screwdrivers) this will reveal one bolt, remove this and wheel should slide off.