Real Oakley sunglasses are made with high-quality materials and undergo rigorous testing to ensure durability and protection from UV rays. On the other hand, fake Oakley sunglasses are often made with lower quality materials and do not provide the same level of protection or durability. Additionally, fake Oakley sunglasses may not have the same level of craftsmanship and attention to detail as genuine ones.

To replace the lens in Oakley Minutes sunglasses, first open the nose bridge and gently push the lens out from the top corner. Then, align the new lens with the grooves on the frame and push it into place. Ensure the lens is securely in place before closing the nose bridge.

No, it is not legal to sell Oakley lookalike sunglasses as they may infringe on Oakley's trademark and design rights. It is important to respect intellectual property laws and avoid selling counterfeit or imitation products.

The Oakley Library is located at 1050 Neroly Road, Oakley, California, 94561.

I have fixed eyeglass frames with Le Pages 5 minute Epoxy. The repair held for almost 5 years.

Take the glasses from whoever you are checking and break them. If they get really mad, they are probably true Oakleys. If they only get irritated, they are fakes.

No, they will not.

I managed to get mine to fit by marking off how much material to remove off of the bottom and side edges of the lens, masking off the front of the lens, and using a high speed rotary tool w a sanding attachment to actually remove the material. Takes a steady hand and a Dremel.

Also, you have to take just a small amount of material off of the pointed tabs located towards the nose piece on each lens.

Prescription lenses are ground to fit the frames. They may or may not fit the the new frames properly. The best thing to do is take the glasses and the frames to an optomotrist.

The only difference is that xlj lenses have a concave lower edge to them, standard lenses are convex. Basically xlj gives you more 'cheek clearance'.. Both will fit fine in any half jacket frame. Answering these questions is fun

!

I just finished 're-socking' my Oakley C-wire sunglasses last night, so I can offer some insight.

I began by removing my old socks, wiping off the residue that remained with a dry paper towel, and then cleaning the entire earpiece area well with glass cleaner. Then I began to attempt to slide the new earsock on. It was so difficult that I was afraid that I was going to bend my frames, so I had to remove the sock and start over.

An important first step is to put a small dab of water-based lubricant on the very tip of the earpiece, where the sock will be started. (You can prolly also use petroleum-based jelly, but I don't know if this might possibly damage the sock, over time.) Don't use much, only a bit is required!

Now start the sock onto the earpiece, pushing it on in the correct alignment. If it starts to 'slow down' on you, simply use your finger to move a bit of the 'bead' of lube out in front of the sock onto the remaining, uncovered earpiece. If the sock begins to get out of alignment or twist at the rear portion, back at the end of the earpiece, realign it correctly and continue.

Once you have gotten the sock to the correct location at the front of the earpiece (towards the hinge and lens), you may find that it tries to 'retract' itself backwards towards the end of the earpiece. This simply means that you haven't yet advanced enough of the back portion of the sock onto the earpiece: in other words, it is in a 'stretched' condition. Just push a bit more of it onto the earpiece from the back of the sock until it stops trying to pull itself back. Then, again, ensure correct alignment of the sock.

Note: If you begin this process at a time when you can allow the glasses to 'sit' for a few hours (i.e., sock them one evening, and allow to sit all night), then you can be certain the socks won't try to 'retract' on you. This way when you trim the excess you'll be certain it will truly be the correct length, leaving no gaps in the front or back of the earpiece.

Also, if you're still having trouble, you might try heating the sock up a bit with a blowdryer to expand the material before you slide them onto the earpiece.

Hope this helps! Flex

Don't use any petroleum-based substance on an ear sock. It will rot the rubber. Try this instead of Vaseline: Dishwashing liquid. That's right Oakley lovers, it works great. Put a little on the end of the earpiece and inside the ear sock. It will slide right on, and then you can rinse off the soap! Love those Oakleys!!

Scott

Jim Jannard

No, the pad-to-frame has a different interface, though, the Straight Jacket nose pads will fit with the Scalpel frame.

We recommend calling Oakley at 1-800-403-7449. These are provided for free from their repair department.

They are Oakleys with clear lenses, that I am certain of. As for which type it's either Oakley Flak Jacket or Oakley Half Jacket.

Yes Oakley Flak Jackets meet ANSI Z87.1 impact testing!

XLJ Lenses are for the Half Jacket, while XL lenses are for Half Jacket 2.0's!

The lens size is the only difference the XL have a bigger lens.