Volume

A pile of gold that is 1 metre long, 1 metre wide and 1 metre high.

There is 0.134 cu feet per gallon of water, so that means 16000 gallons would consist of 214.4 cubic feet.

no 5 gal = 20 qts

1 gallon = 4 quarts

1 quart = 0.25 gallon

The volume of a cylinder in any position will be the area of the circular end, or top, times the length, or height, along a side. The area of a circle is pi x radius2, where the radius ("r") is half the diameter ("d"), the distance across the circle. Calling the length or height of the cylinder "h", the volume of the cylinder is calculated as: V = (pi x r2)h = (3.1416 x (d/2)2)h Example: What is the volume of cylinder 12" long and 6" across the circular end? V = (pi x r2)h = (pi x (d/2)2)h = (3.1416 x (6/2)2)12 = (3.1416 x 32)12 = (3.1416 x 9)12 = 28.2744 x 12 = 339.3 cubic inches. Be sure to use the same units for r, d, and h. Pi is always 3.1416 (rounded).

Approx 6960 beans.

That is 192 teaspoons.

245ml

That depends upon the substance that makes up the 1400 liters, and at what temperature and pressure that substance is.

What you are asking for is the density of the substance as that can be measured in grams/cu cm. The volume of the substance makes no different as the density is constant (at a given temperature and pressure).

If you had 1400 liters of mercury (at 0°C, 101.325 kPa), it would be 13.534 g per cu cm.

If you had 1400 liters of hydrogen (at 0°C, 101.325 kPa), it would be 0.00008988 g per cu cm.

If you had 1400 liters of water (at 0°C, 101.325 kPa), it would be 0.9998675 g per cu cm (which is near enough 1 g per cu cm).

Water is its densest at 4°C, when it is 0.9999999985 g per cu cm.

Fifty gallons are equal to 189.271 ltters of water.

16 fluid ounces in one US pint

move the decimal (starting from the left) three times and you get .063 and that's your answer

You measure the inside depth, length and height and then multiply them.

Divide by 1000

= 2560/1000 liters = 2.56 liters

Depends on the shape, if it's a cylinder then find the radius of the circle on the end by measuring the diameter in feet and halving it. Then multiply it by itself and the multiply it by pi (~3.141593); this is the area of the circle in square feet. Multiply this by the length of the tank (measured in feet) to get the cubic feet.

That is approximately 355 ml.

1000 cubic centimetres = 1 litre 100 cubic centimetres = 0.1 litres 50 cubic centimetres = 0.05 litres

A tonne is a measure of weight

A cubic meter is a measure of volume

There is no direct conversion.

They are related by the density of the substance, the greater the density, the smaller 1 tonne will take up, for example 1 tonne of Hydrogen takes about 11000 m3 whereas 1 tonne of mercury takes about 0.074 m3.

300 i think roughly =/

In the US Natural Gas output is measured in cubic feet, First you must convert feet to meters: 3.28084 fpm, then we must determine cubic feet per cubic meter, 3.28084 X 3.28084 X 3.28084 = 21.528 cubic ft in a cubic meter and since there are 1000 btu in a cubic foot of Natural Gas 21.528 x 1000 btu = 21,528 btu/cmtr. Then you must convert kWh to btu. 1kWh=3413 btu, so 21528 btu divided by 3413 btu = 6.307 kWh in a cubic meter of NG: so 1 cubic meter divided by 6.307= 0.1585 cubic meters of NG = 1 kWh. Of course these are output ratings not input. So depending on the efficiency rating of the NG furnace being used one would need to add the heat that is lost up the chimney or the inefficiency rating for an accurate answer. For example with an 80% efficient gas furnace one would need to add 20% or 0.032 to the 0.1585 cubic meter value we got earlier to allow for waste and the answer is actually 0.1905 cubic meters total input of NG needed per kWh produced. I hope this is right... End -H2045

7 ml

At sea level and 15 deg C, the weight of a cubic metre of air is approx 11.0 Newtons.

36 cubic feet equals 925.7 dry quarts.

A "cc" is a cubic centimeter. Because the metric system is awesome, 1 ml is 1 cc. Therefore, 200 ml is 200 cc. That would be a pretty big shot. Many typical vaccinations are around 1ml or so. 200ml is pretty much an IV bag of liquid.

You're probably wondering because of alcohol, so 3000 ml would be about 100 shots.