0
In Cisco networking, a NACK (Negative Acknowledgment) command refers to a message sent to indicate that a particular packet or frame has not been received correctly or is missing. This mechanism is often used in protocols that require reliable data transmission, allowing the sender to be notified of errors and resend the lost or corrupted data. In Cisco devices, NACK can be part of protocols such as TCP or other reliable transport mechanisms, ensuring data integrity across the network.
What else can I help you with?
What is the command line interface used for on a cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What is the command line interface used for a Cisco router?
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
What are cisco device configuration commands?
cisco configuration command guide
What do the commands for the Cisco switch IOS allow the user to do?
The Cisco IOS commands allow the user to enter partial Cisco IOS commands. If you start to type in a command it can recognize it and finish the command for you.
What password would be set by issuing the following command enable secret password cisco?
Cisco
How do you remove a static route from a routing table?
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
How can the hostname can be removed in cisco?
With the following command: No hostname
What does the command no shutdown do on a Cisco device?
Enables the interface.
Definition of the word nack?
nack
What is cdp neighbor?
This is a command line use in Cisco devices to show neighbors which is using Cisco Discovery Protocol (CDP).
What is the longest Show command in a Cisco device?
The show tech-support command will give you the longest output.
What is the birth name of William Nack?
William Nack's birth name is William Louis Nack.
