answersLogoWhite

0

What else can I help you with?

Related Questions

What are the ways for 8085 microprocessor to exit from wait state?

The only way to exit WAIT state on the 8085 is to assert READY. You could perform a reset, but the processor will still remain in TWAIT if READY is not true.


When ready signal is sampled by the processor?

The READY signal of the 8085 microprocessor is sampled approximately one half clock after the trailing edge of ALE and, if not asserted, repeatedly one full clock cycle later until it is asserted.


What do you mean single and double handshaking of microprocessor 8086?

They are the ways of transmitting parallel data to the microprocessor. In single handshake, a peripheral device first sends a "Strobe signal" to the microprocessor to indicate that it is ready to send data. The microprocessor , upon detecting the strobe signal, opens up its input port and receives the data. After receiving data, it sends an "Acknowledge signal" to the peripheral to indicate that transmission has been completed.A transmission session has been completed. In double handshake, first the peripheral device sends a strobe signal, the microprocessor, sends the acknowledge signal to indicate that it is ready to receive data. After which data is received.After sending data, the peripheral sends a strobe signal to indicate data transmission completion, due to which, the microprocessor drops its acknowledge signal and a session has been completed. The only difference in the two is that, in double handshake, the peripheral is informed about the microprocessor's readiness to receive data. This is doesn't happen in single handshake. So the name follows "double handshake", literally meaning "double confirmation".


What will happen to a female fighter fish if she has eggs but doesn't mate?

Nothing special will happen to her. If she fails to find a mate once she is ready to spawn the ova will simply either remain in her body waiting for her to find one or they will be reabsorbed back into her body from where they developed.


What happen to the product after they are formed?

ready for...................


What is contingency conditioning?

Getting ready for anything to happen.


What is the function of ready pin of 8085 microprocessor?

The READY pin on the 8085 microprocessor is used to delay the completion of a bus transfer cycle. It is sampled by the 8085 at the falling edge of clock following ALE. If it is high, the cycle completes. If it is low, the cycle is extended by one clock, with all lines held steady - then it is sampled again at each of the next falling edges of clock until it is high. The purpose of READY is to allow (usually) memory devices to operate at a slower speed than the 8085.


What song has ready ready ready just let them go?

"It really really really could happen Yes it really really really could happen When the days they seem to fall through you Just let them go" by Blur


What should remain in place until the EED is actually ready to be installed?

shorting clips/shunts


What does happen when animals ready to mate?

they eventually mate together


If the guy you are liking isn't ready for a relationship with you but says it is bound to happen what do you do?

Wait until it does happen. Maybe try to encourage it to happen.


What would happen if you made an umbrella out of paper?

Nothing would happen. There are all ready paper umbrellas.