4 T-states as usual and 2 more are required to perform n*8
its result gives the vector address of interrupt service routine(rstn is an software interrupt)
I'm not quite certain what you're asking, but three versions of the 8085 processor were released; 3, 5 and 6 MHz.
3 T states for instruction fetch, 1 T state for decode, 1 T state for register E decrement, 1 T state for possible register D decrement.
The Intel 8085 is an 8 bit microprocessor created in 1977.The Intel 8086 is a 16 bit microprocessor created in 1978. The 8086 was the first chip to start the x86 architecture family.8085 contains 16-bit address bus and 8-bit data bus8086 contains 20-bit address bus and 16-bit data bus..In 8085 the clock speed is 3MHZwhere as in 8086 the clock speed is 5MHZ.there are two differences btw 8085&80861. 8086 has 6 byte queue but 8085 has 4 byte queue2. 8086 has 16 bit data bus where as 8085 has 8 bit data bus
AMD Athlon microprocessors are the awesome. They're 6 core meaning that it's processing power is equivalent to 6 amd separate processors.
6 general purpose registers.i.e., B,C,D,E,H,L
Computer Science 1(Software)- 1.Operating Systems 2.Classes and Objects 3.Constructors and Destructors 4.Operator Overloading and Type Conversions 5.Inheritance:Extending Classes 6.Pointers,Virtual Functions and Polymorphism 7.Data Structures 8.C++ 9.HTML 10.Visual Basics(Only for Practicals) Computer Science 2(Hardware)- 1.Introduction to Microprocessors and Organisation Of 8085 2.Instruction Set and Programming Of 8085 3.Introduction to Intel X86 Family 4.Introduction to Microcontrollers 5.Networking Technology -CSB.... ;P
Since the 8085 has a maximum clock frequency of 6 MHz, increasing the crystal frequency from 5 MHz to 20 MHz, a corresponding clock frequency change of 2.5 MHz to 10 MHz, the chip would malfunction.
The clock speed of the 8085 depends on the particular chip chosen. The basic 8085 could run up to around 3 MHz. The -1 version could run up to around 6 MHz. The -2 version could run up to around 5 MHz. In each case, the crystal frequency had to be exactly twice the desired clock frequency, i.e. 6 Mhz, 12 MHz, and 10 MHz, respectively. In all cases, the minimum clock frequency was 500 KHz. (Crystal 1 MHz)
The 5.5 in RST 5.5 means that the interrupt vector is located between RST 5 and RST 6.
different microprocessors take different number of states. without knowing processor its not possible to comment.
The name, RST6.5, was chosen because the interrupt vector lies halfway between RST 6 and RST 7, specifically at address 0034H.
The state with 6 consonants in a row is Mississippi.