0
Yes! a coaxial cable can go bad. Yes! you can suddenly lose the signal from an atenna because of a bad cable. A a new coaxial cable may fix the problem as long as the damaged cable is the source of the problem. However if the signal problem is at the tap or one of the splitters in your home you will need to call your cable company to fix the problem.
What else can I help you with?
What do you need to hook up new tv to outdoor antenna?
You will need a tv antenna and a coaxial lead in wire with connectors.
Why does the FM reception not work on a 1998 Dodge Dakota radio?
Sounds like an antenna or coaxial cable problem, especially if you're still getting some AM frequencies. AM receivers can often pick up stations even with the lack of antenna input, but FM receivers are pretty unforgiving. Check that the coaxial cable is plugged properly into the back of the radio, then check, if necessary, the connection at the base of the antenna, assuming the antenna is still there. Those are the two most likely locations for coax trouble.
What modem uses coaxial cable?
A coaxial cable has great uses in television antenna connections. TV satellite connections also use coaxial cables to connect decoders to the TV set.
Can I use any coaxial cable for internet connection?
No, not all coaxial cables are suitable for internet connection. It is recommended to use a high-quality coaxial cable specifically designed for internet use to ensure optimal performance and reliability.
How do you remove the power antenna on a Hyundai accent 1998?
Answer1998 MY (model year) Accent vehicle do not have a power antenna. Antenna mast should simply unscrew from mount.Step 1Activate the antenna switch to the up position.(turn on radio)Step 2 Using the wrench or needle-nose pliers, loosen and remove the original retaining nut on the base of the antenna mast.Step 3 Gain access to the underside of the area where the antenna is located.Step 4 Remove the bracket or brace that is below the hole and holding the antenna in place.Step 5 Remove the mast.Step 6 Find the motor that controls the antenna mast. Generally, power antennas will have a constant 12-volt lead and a ground lead. The ground lead will be grounded to the panel next to the motor.Step 7 Remove the ground lead from the panel.Step 8 Pull out the antenna coaxial cable.Step 9 Unplug the coaxial from the extension coaxial cable.Step 10 Remove the original antenna coaxial cable. Note the route the cable follows.Hope it helps
What does an old tv need to get antenna reception?
To receive antenna reception, an old TV typically needs an external antenna, which can be either an indoor or outdoor type, depending on the reception quality required. Additionally, if the TV does not have a built-in digital tuner, a separate digital converter box is necessary to decode digital signals. Finally, proper connection using coaxial cables between the antenna, converter box (if applicable), and the TV is essential for optimal reception.
Technical term for the kind of cable that carries a tv signal?
There are two types of cable used for television radio frequency signals: 300 ohm twin lead flat cable and 75 ohm coaxial cable. The twin lead is typically used with a rabbit ears antenna and coaxial is typically used with roof top antenna or cable TV setups.For television baseband video signals coaxial cables are usually used.However for digital television baseband video signals these are not adequate and special cables (e.g. HDMI, DVI, DisplayPort) are used. These cables are typically many twisted pairs in a common shield.answer is Coaxial cable
Does your new tv hAVe a AV port on it for your nes or do they not do that anymore?
You should be able to connect the RF adapter that came with you NES into the coaxial cable port on your tv even though you probably don't use that connection anymore for your cable or satellite connection. Then all you have to do is put your tv on the antenna/cable input and tune it to channel 3.
What is the easiest way to get HDTV from your antenna to your projector?
Coaxial cable, RG6u or RG 59u. The RG6u has less loss for longer cable runs.
What if your tv pictures are double what is wrong?
Sometimes this will happen if you are using a coaxial cable on the antenna and there is a broken connector or even a cut in the cable somewhere.
What is a good cordless phone extender?
You can buy these products,but you could also rig one your self with an old antenna and some coaxial cable.
Could you use a stripped coaxial cable as a antenna?
Yes, a stripped coaxial cable can be used as an antenna, but it may not perform as well as a purpose-built antenna designed for that specific application. The length and diameter of the cable, as well as its impedance, will all affect its ability to receive or transmit signals effectively. It may work in a pinch, but for optimal performance, it's best to use a dedicated antenna.
