answersLogoWhite

0

By using Q20 lubricant oil and a pair of water pump pliers. You can lube up the rusted nut, this type of oil really sets in and gets to those hard to reach areas and then you can loosen the nut with the water pump pliers because they grip really well. Otherwise cutting the back of the nut with a hacksaw blade will have to be used as option.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How can I remove a rusted screw from a license plate?

To remove a rusted screw from a license plate, you can try using penetrating oil to loosen the rust. Let the oil sit for a few hours or overnight, then use a screwdriver or drill to carefully remove the screw. If the screw is still stuck, you may need to use a screw extractor tool or seek professional help.


How do you remove the hub nut on 1993 metro in order to remove the rotor?

I dont think you remove the nut in the center of the hub, your rotor is more than likely just rusted on to the hub.


What size is the rusty nut and where can you get a socket to fit the nut?

Sears sells a special socket to remove rusted, stripped and broken nuts.


What can make a rusted screw unrusted?

While you can't really remove the rust, you can use penetrating oil to help get the screw loose, and you can use sandpaper on it to remove the rust you can get to.


Why you use the long spanner to open the rusted nut bolt?

you use a spanner to open a rusted nut bolt because you need a strong tool to open a rusted nut bolt.


How do you remove a window motor on a Chevrolet truck?

to remove the window motor you have to drill out the rivets and replace them with a standard screw and nut and making sure that the screw is not to long.


How do you remove a rover 200 headlamp unit?

first remove indicator lens ,screw on inside of wing.Then remove screw at side of removed lens both upper bolts and then remove nut from underneath headlight.


What is the difference between screw and nut?

A nut is called screw when its head is tightend in component .but in case, tight of nut is not possible without bolt.since screw is tight without nut bolt it is not possible in case of nut.


How do you replace rear bumper 1992 300e?

First, remove the nut from the middle of the bumper, and then remove the nut from the the mounts at each rail frame. Then remove the nut or screw holding the bumper to the car at the area of the wheel. Remove the old bumper, put on the new bumper, and replace the screws in nuts in the reverse order.Ê


How do you remove Front Rotors on a 2005 Jeep Grand Cherokee?

Remove the Wheel and then remove the caliper after that you will need a 36mm axel nut socket ..they run about $20 bucks... remove the axel nut... the big nut in the center of the rotor. then you will need to carefully remove the black rubber ring where the rotor attaches in the center after that you should be able to pull off the rotor.. you may need some wd40 and a prybar or a hammer they can be rusted on.


How can I remove a stripped nut from a bolt?

To remove a stripped nut from a bolt, you can try using a pair of locking pliers or a nut splitter tool to grip and break the nut. Another option is to use a drill to create a small hole in the center of the nut and then use a screw extractor to remove it. If these methods do not work, you may need to cut the nut off with a hacksaw or angle grinder. Be sure to use caution and wear appropriate safety gear when attempting to remove a stripped nut.


How do you remove a distributor cap screw bolt rusted stuck without destroying distributor?

Most of the time it breaks off and you will need to drill it out and replace screew.