answersLogoWhite

0

What else can I help you with?

Related Questions

when tripping pipe in the hole do you close the elevators before running them up to Derrick man?

when tripping pipe in the hole do you close elavaters before running them up to the derrikman


Can a hole in a polyethylene pipe be fixed with hot melt glue?

Possibly if there is little pressure in the pipe -(ie if it's a drain pipe) . For a pressure carrying pipe,I would cut out the hole and replace with a long coupling, or a short piece of pipe and 2 couplings.


How can I effectively repair a hole in a copper pipe?

To effectively repair a hole in a copper pipe, you can use a pipe repair clamp or a soldering technique. First, turn off the water supply to the pipe. Clean the area around the hole and apply a pipe repair clamp over the hole, tightening it securely. Alternatively, you can cut out the damaged section of the pipe and solder a new piece in its place. Make sure to follow safety precautions and consult a professional if needed.


How can I fix a hole in a PVC pipe?

To fix a hole in a PVC pipe, you can use a PVC pipe repair kit or epoxy putty. First, clean and dry the area around the hole. Then, follow the instructions on the repair kit or epoxy putty packaging to apply the material over the hole. Allow it to dry and cure according to the instructions before using the pipe again.


How can I repair a hole in a PVC pipe?

To repair a hole in a PVC pipe, you can use a PVC pipe repair kit or epoxy putty. First, clean and dry the area around the hole. Then, follow the instructions on the repair kit or epoxy putty packaging to apply the material over the hole. Allow it to dry and cure according to the instructions before using the pipe again.


How do you patch a pin hole in a metal pipe?

This is hard to answer with out knowing what type of metal. what the pipe is being used for, the amount of pressure that may be not the pipe.


Can you solder a hole in a pipe?

Copper you can. Treat it as you would any other connection, clean the area, surface and hole, get the moisture out and solder a patch over it. Small hole, you can just use solder or you can cut a small piece of pipe in half, clean and flux it and put it over the hole. Steel pipe, you can braze over the hole, same basic process as soldering, clean and fill with braze.


Is it bad that the radiator's exhaust pipe has a hole?

Radiators do not have exhaust.


What is casing pipe?

it is defined as the pipe cemented in the well to seal off formation fluids and to keep the hole from caving in.


How do we get oil from underground?

Drill a hole in the rock until you get to the oil. Insert a steel pipe into the hole, and pump the oil up from the bottom of the hole.


How do you tap a hole for an EGR pipe into the head on a JDM EJ25?

acquire correct tap from hardware or automotive supplier. Drill smaller hole through EGR port boss on head. Drill larger hole , size stated on tap to same depth as on intake port. then tap. If metric thread tap cannot be acquired a tapered pipe thread tap will also work. Threads are very close and will seal because of taper.


Why is there a hole in lake berryessa?

It's a drainage hole so the dam doesn't overflow.