answersLogoWhite

0

Go to your Plumbing or hardware store, and you find a special tool for this job which resembles a large socket or wrench.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you loosen the heating element on an electric water heater?

It should be held on with a nut. 1 1/4 deep socket or maybe 1 5/16, something in that range. 6 point preferred.


How do you change a heater core on a 1986 Chevrolet truck?

Loosen the dash and pull out the complete heater box after you have disconnected the heater hose from the firewall...........


How do loosen up hard to pull cord on electric mower?

Electric mowers do not have pull cords.


How do you change a block heater on a 1981 GM truck?

Locate the block heater. Drain out the coolant from the rad and from the block if there is a drain there. There should be a screw in the center of the block heater. Unscrew it to loosen the block heater internal clamp. Use a pair of pliers and wiggle it free. As long as it is not plugged in, there should be no worry of damage. It is sealed with an o-ring.The element will have to be worked out as it goes into the block along the side.


Why is a 1992 Dodge caravan getting little heat after changing the thermostat?

Possible air lock in the heating pipes. Common after changing thermostat. look for a bleed screw on the heating pipes between the engine and interior, or loosen one of the heater pipes., after engine has warmed up. Run engine to dislodge trapped air.


Can you hacksaw through caliper screws?

No, then remnants will be in your spindle. If they are stubborn, try heating them with a propane torch. Rapid heating/cooling may loosen.


What can cause terminated wires to loosen resulting in broken or intermittent connections?

Heating and cooling Vibration


How do you replace a heater core in a 1967 skylark?

Raise the froth of your car. Drain the radiator. Remove the heater tube from firewall and loosen the hose clamps. Lower the vehicle after draining the antifreeze. Locate the heater core and remove the mounting clamps. Remove the heater core and replace it.


How do you replace the heater hoses on a 1993 ford explorer?

loosen the clamp holding the hose on to a fitting and pull the hose free.


How do you replace the heater core on a 1999 Dodge Caravan?

Drain the radiator. Disconnect the heater hose connections at the fire wall. loosen the dash screws and pull it out, just enough to reach the heater core. Unbolt the core and pull it out. Revers the process for installation.


Where is the location of the heater blower motor on a 1998 GMC Suburban?

The A/C - Heater blower motor will be located on the passengers side behind the glovebox and you will have to loosen the dash on that side and pry it up very carefully.......


Why is it sometimes possible to loosen cap on screw top bottlesap briefly in hot water?

Heating the bottle cap causes it to expand, making it easier to loosen. This is particularly useful if the cap is stuck due to contraction in cold temperatures. The brief heating allows for the cap to slightly expand and become easier to twist open.