Penetrating oil (WD40) can work wonders. Apply liberally, give it 10-15 minutes to work its way in, and try again. Repeat if necessary. If all else fails sometimes heating it with a torch can loosen it, but this can be very dangerous (especially in close quarters) so it should be your last option.
A tourniquet must be loosened only in the event of a deep laceration. When one has been applied due to amputation, it should not be loosened. Loosening a tourniquet for a laceration, blood flow can continue continue to other tissue so that an amputation does not become necessary.
Loosening one bulb in a series circuit will break the circuit and cause all the bulbs to turn off. In a parallel circuit, loosening one bulb will not affect the other bulbs, and they will remain lit.
loosen the alternator bolts to get that belt off and the other belt is loosened by loosening the power steering reservoir bolts.
even with the tensioner loosened all the way i still cannot get the belt on. Any suggestions on how to get the belt on?
You can relieve the tension on your 1994 Mitsubishi Gallant belt by loosening the tensioner pulley. The tensioner pulley can be loosened by turning the retaining bolt to the left.
You can change the serpentine belt on your Chevrolet trailblazer, by loosening the tensioner pulley. With the loosened tensioner pulley the belt will come off easily. Tighten the new belt with the tensioner pulley.
When breaking a tool joint on an oil rig, the breakout tong is placed on the lower part of the joint to grip it firmly while the upper part is loosened.
The 2002 Toyota Camry belt tensioner pulley can be loosened by loosening the pulley nut. The pulley nut is located in the center of the pulley.
Yes, loosened is the past participle of loosen.
She loosened the rope from around the pole
"i loosened up my skates" or anything that can be loosened up in a statement of the past or like what i just used it in
you start by loosening the tension pulley that's actually hooked to the alternator(right off the top bolt), once this is loosened, you can move the alternator back to where the belt fits and tighten it back up and your done