answersLogoWhite

0

Have you checked the stop cock to the other faucet?

has the other faucet been connected?

has the washer jammed the inside of the tap?

is the head part fault free?

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why do sink faucets have aereators?

They mix air with the water so that it doesn't have as much force coming out of the faucet and splashes less.


Why does the car heater blow cold air until driven for a while?

it has to heat up, just like water has to warm in the faucet.


After a double handle faucet was replaced with a single one air started coming out with the water what is wrong?

the new one has a aeriator that's working right


How do you get the air out of the line after installing new faucet?

Very simple. Run each faucet until there is no more air. This usually only takes a minute or two per faucet. Remember air is lighter than water and will quickly rise, thus exiting the faucet additionally the strong flow of water out of the faucet is a huge plus.


When you had a new hot water heater installed why was there no water coming from hot water faucet?

If no water is coming from the hot water faucet after a new hot water heater installation, it could be due to air trapped in the pipes, which is common after installation. Another possibility is that the hot water heater hasn't been filled properly or the shut-off valve is closed. Additionally, sediment buildup in the pipes or a malfunctioning faucet could also prevent hot water from flowing. It's advisable to check these factors or consult a plumber for assistance.


How cold is the air coming out of the vents when the air is on?

It's somewhat cold. It's just very little cold air coming out. Can't hear the vent blow the air as well.


How do you get air out of waterlines on city supplied water?

To remove air from city-supplied waterlines, you can start by turning off the water supply and opening the highest faucet in your home to allow air to escape. Then, open the lowest faucet or a drain valve to release any trapped air and water. Afterward, close the lower faucet and turn the water supply back on, allowing water to flow until it runs smoothly without sputtering. Finally, close the higher faucet once the air is purged and water flows steadily.


Why does the faucet add bubbles to water before it comes out?

The faucet aerates the water by mixing in air, which creates bubbles. This can help improve the water flow and reduce splashing when the water comes out of the faucet. Additionally, aerated water can feel softer on the skin and be more visually appealing.


Why no cold air from ac on Honda Odyssey?

If there is no cold air coming from the air conditioner on a Honda Odyssey the condenserÊmay have failed. No cold air coming from the air conditioner can also mean that the unit needs to be recharged.


Why does my New faucet makes clunking noise?

There was air in the line. When you turn off the water with the faucet running make sure you turn it back on with the faucet open. That will release any air caught in the lines. That faucet shut with one on a lower floor on and restoring water does not work. Fast and easy. 1. turn on affected faucet 2. shut off water 3. turn water back on 4. faucet should be running smoothly now


What is the relationship between air pressure and a water tank?

The relationship between air pressure and a water tank is that the air pressure in the tank affects the flow and pressure of the water coming out of it. The air pressure in the tank helps to push the water out when a faucet is opened, creating a steady flow of water. If the air pressure in the tank is too low, the water flow may be weak or inconsistent.


What causes a whistling noise coming from the shower faucet the faucet to fill the tub the whistling is constant Any ideas on how to fix it and if it going to cause serious problems?

A whistling noise coming from the shower faucet or when filling the bathtub could mean that there is excess air in the water line. This can be fixed by turning off the major water supply valve and then opening all of the faucets in the home for about 5 minutes. Shut all of the faucets off, then turn the water supply back on.