1st. you have to find the master code located on the inside of the trunk , enter code, within 5 sec press 1/2, then enter code, make sure to enter code digits with less than 5 sec between each, to erase enter master code then press 1/2, wait 6 sec.
This web site shows you how to do that and more. http://www.lincolnsonline.com/tech/tech.html
im the one asking the question because i dont know how to do it. how van i contribute to the answer?
that module should be located in the trunk up against the back seat, youll find a few of them there.
Ou812
To reset the keyless entry system for a 1994 Ford Crown Victoria, start by disconnecting the vehicle's battery for about 10-15 minutes to clear the system. Reconnect the battery, then enter the vehicle and close all doors. Press the "lock" and "unlock" buttons on the remote simultaneously for about 15 seconds, then test the remote to ensure it's functioning properly. If needed, consult the owner’s manual for specific instructions related to your vehicle.
thats my question to you
No , just the factory code and a personal code if it has been entered
One way would be to take the VIN number to a Ford dealer, they would be able to tell.
If the alarm is sounding (horn honking/lights flashing) you push the panic button on your key fob to shut it off. The alarm is disarmed when you unlock your door(s) by using the key, keyless entry pad, or the unlock button on your key fob.
according to a question i found elsewhere here ("What module is under the center console?") it is supposed to there apparently, under the center console
pick it or call a locksmith
They are all essentially the same, though some more minor improvement were made starting in 1994 with keyless entry alarm for one