twice the caliper plus 2 or 67 max
10-100 usd
The value of a Jukar black powder pistol can vary significantly based on its condition, age, and specific model. Generally, prices can range from $100 to $400. Collectible or rare models may fetch higher prices, while those in poor condition may be worth less. For an accurate appraisal, it's recommended to consult a firearms expert or check auction sites for current listings.
fill it all the way up get 1000 fps no worry about blowing up
27 grs of FFF Blackpowder.
The best way to determine actual value is to search the on-line auctions, such aswww.gunbroker.com and www.auctionarms.com or even www.proxibid.com enter your details in the search and see what has SOLD and for how much. if there is nothing current try the archives of past sales or items sold. Another place to look is The blue book of modern black powder values available from www.midwayusa.com Don't forget condition has allot to do with value, so compare apples to apples.
You need to contact the maker or get a book on Blackpowder shooting that has loads in it. Different types of weapons and projectiles and powders will determine what is a safe load.
There are hundreds of possible loads, depending on WHICH powder, and WHICH bullet. Rather than give you a load, we would rather refer you to a good reloading manual. Lyman makes a very good manual. The amount of powder must be correct for THAT type of powder AND the weight/type of bullet used.
An awful lot.The amount of "powder" added to a case can have several effects.Velocity: - The more powder the greater the velocityAccuracy: - All guns react differently to the amount of powder. High velocity does not mean better accuracy. You need to experiment to find out which load suits your rifle/pistol.Safety: Too much powder can cause the casing to rupture. Always follow the reloading guide and never go above the maximum load.
In my short barrels I use 15 grains of 3F black powder. You can fiddle a bit with the amount +/- to do what you need, but I found it to be a good load for up to a 4" barrel.
None. A primer does not contain propellant powder- it contains an explosive that ignites the powder. If you mean how much propellant powder is in a 9mm cartridge, that will depend on which 9mm cartridge (there are nearly a dozen different 9mms) which weight bullet, and which powder. My basic reload data table for 9mm Parabellum (9mm Luger) is 3 pages of data with different powders, bullets, etc. A basic load is 4.5 grains of Bullseye powder with a 115 grain bullet.
70 grains with a round ball works best for me. Anything under about 50 or over 80 and it starts to get erratic.
dr eq = drams equivalent. Black powder used to be measured in drams, which was a measure of the volume of black powder used in a load (basically the amount used). When smokeless powder came along later, both smokeless powder and black powder existed at the same time for a while. A smaller amount of smokeless powder was equal in power to a larger amount of black powder. To keep things simple shells using smokeless powder were referenced to how many drams of black powder would be needed to produce similar results. This continued into modern times. A shell marked 3 1/4 dr eq is roughly equal to a black powder load of 3 1/4 drams. This allows an idea of how much power a shell has regardless of the actual amount of powder that is inside the shell.