fill it all the way up get 1000 fps no worry about blowing up
I would need to know the caliber and type (revolver, single shot. flintlock, percussion) to answer the question exactly, but the best place to start is with as many grains of powder as the caliber divided by half for a hand gun or revolver as a MAXIMUM LOAD. So a .45 cal. would be about 20-23 grain. I usually start out around 12-15 grains and work from there.
It would depend on how the cartridge was loaded, ( powder type and amount and bullet weight's) A modern black powder load would be to about 100 yards. After that the velocity and energy drops dramatically. Smokeless powder loads would extend a bit farther.
Depends on the load
The recommended amount of black powder for a 1858 Pietta revolver typically ranges from 20 to 30 grains, depending on the caliber and specific load you are using. It's essential to consult the manufacturer's guidelines or a reliable reloading manual for precise measurements and safety recommendations. Always ensure to use the appropriate type of black powder and follow safe loading practices.
The powder charge for a .44 caliber revolver can vary depending on the specific cartridge and load being used. For example, a typical load for .44 Special might use around 5 to 6 grains of Unique powder, while .44 Magnum loads can range from 20 to 28 grains of powder, depending on the bullet weight and desired performance. Always refer to a reputable reloading manual for precise measurements and safety guidelines.
A black powder pistol (single shot) in 44 caliber should take a .420 - 435 ball, A revolver on the other hand will take a .451 - 454 ball, the reason being when you load the cylinder of the revolver with a larger ball than the bore, you will shave a small ring when you ram the ball over the powder, thus creating a tight seal that prevents the gases from escaping around the ball and lessening the chance of a crossfire (several chambers going off at once) I have included a link to a pictorial guide that can explain far better than I can.
Need more of a description. Are you talking about a Black Powder revolver? Is it an original or reproduction? Depending on what you have and the condition it is in it could be worth as little as 100 or tens of thousands of USD Need more of a description. Are you talking about a Black Powder revolver? Is it an original or reproduction? Depending on what you have and the condition it is in it could be worth as little as 100 or tens of thousands of USD
It is a Mountain Stalker. You should contact customer service, and get an owner's manual for your rifle. A .54 caliber rifle will use ABOUT 80-90 grains of black powder per shot. The exact load will depend of whether you are shooting round patched ball, Maxi-ball, or sabots.
Without a doubt yes, given the proper load and accurate shot. Though it is not legal to use less than .45 caliber in most states now, some time ago my father and I hunted in New England with .36 caliber black powder rifles with great success.
It would depend on the caliber, type and maker. ie. 45, 50, 54 caliber, smooth bore, rifled barrel, antique, older reproduction or modern steel But a safe place to start is with as many grains of black powder as the caliber, ie. 45 cal = 45 grains of powder. Depending on the conditions above you can go from there.
Here is a link posted in the related links section, to the basics of loading a revolver. Remember to always keep your face and fingers away form the muzzle and the the open end of the cylinder. http://www.ehow.com/how_2074718_load-blackpowder-revolver.html
load data