Here is a link posted in the related links section, to the basics of loading a revolver. Remember to always keep your face and fingers away form the muzzle and the the open end of the cylinder. http://www.ehow.com/how_2074718_load-blackpowder-revolver.html
fill it all the way up get 1000 fps no worry about blowing up
Need more of a description. Are you talking about a Black Powder revolver? Is it an original or reproduction? Depending on what you have and the condition it is in it could be worth as little as 100 or tens of thousands of USD Need more of a description. Are you talking about a Black Powder revolver? Is it an original or reproduction? Depending on what you have and the condition it is in it could be worth as little as 100 or tens of thousands of USD
I would need to know the caliber and type (revolver, single shot. flintlock, percussion) to answer the question exactly, but the best place to start is with as many grains of powder as the caliber divided by half for a hand gun or revolver as a MAXIMUM LOAD. So a .45 cal. would be about 20-23 grain. I usually start out around 12-15 grains and work from there.
load data
It would depend on how the cartridge was loaded, ( powder type and amount and bullet weight's) A modern black powder load would be to about 100 yards. After that the velocity and energy drops dramatically. Smokeless powder loads would extend a bit farther.
I believe 3 grains of black powder for a start
black powder, bullet patch, projectile.
You can download the manual for the Old Army cap & ball revolver that has loading and cleaning instructions from the Ruger website (see related links) under the customer service heading.
For a 44 cal pistol (not revolver) between 20 and 30 grains of 3F black powder or black powder substitute (like pyrodex or goex pinical) should do the trick. You will have to adjust the load to do what you want and to shoot the distance you want, but that should get you started. The above answer is stupid. Since most black powder pistols ARE revolvers. Fill the cylinder half full or a little more, if you do not want to play around with a grain counter,waste of time.
The powder charge for a .44 caliber revolver can vary depending on the specific cartridge and load being used. For example, a typical load for .44 Special might use around 5 to 6 grains of Unique powder, while .44 Magnum loads can range from 20 to 28 grains of powder, depending on the bullet weight and desired performance. Always refer to a reputable reloading manual for precise measurements and safety guidelines.
Follow manufacturer provided instructions.
To load a black powder gun, first, ensure the firearm is pointed in a safe direction and the hammer is at half-cock. Measure the appropriate amount of black powder using a powder measure and pour it into the barrel. Next, insert a pre-measured projectile (such as a lead ball or bullet) followed by a wadding, if necessary, to keep the projectile in place. Finally, use a ramrod to seat the projectile firmly against the powder, and then prime the pan or add a percussion cap, depending on the type of black powder gun.