0
It depends on the make, model, and year. Some have a threaded pipe at the back of the ski near the nozzle. Some have a connection with a valve near the back of the ski on the inside. Some require you to disconnect a pipe or put a hose pincher on. Check your owner's manual or post your make, model, and year.
CAUTION: You must follow the correct procedure for your particular jet ski. If you turn the water on or off too soon or too late, you can cause serious engine damage or damage to driveline components. The manual will tell you where to hook up too. So if you have to ask this question, you really just shouldn't be doing it.
What else can I help you with?
Where is the water hook up to flush an 89 kawasaki?
where is the water hook up to flush a 89 kawasaki jet ski
Where is the hook up for a hose on a jet ski?
where do you hook up the hose to a jet ski
Does a boat has a propeller?
Yeah most do but jet skis and those sea•doo boats are jet powered
How do you decode a Sea-Doo Jet Ski VIN number?
There is no VIN number on a Sea-Doo Jet ski. There is a HIN number which serves the same purpose. Therefore you cannot decode it.
What are some jet ski brands?
Sea-doo, Yamaha and Kawasaki make jet skiis... not sure if there are any more!! =)
What is the mechanism of propulsion on a Sea Doo?
Sea Doo personal watercraft, like almost all similar types of personal water vehicles, use a jet propulsion system rather than a traditional propeller motor like that on a standard boat. In jet propulsion, a water pump is powered by the engine to build up a set amount of pressure and when that pressure is released it causes the craft to be propelled into motion.
What would win in a race over a quarter mile between a Sea Doo Jet Ski and a Lotus Elite S1?
A Sea Doo jet ski would win .I saw the fastest Sea Doo beat a Ferrari F430 in a quarter mile.If you don't believe me have a look on You Tube.
What is the only reason a jet ski will sink in the water when not running?
It will only do this if, during manufacture, the buoyancy has been left out.
Where are see doo jet skis made?
Sea-Doo jet skis are manufactured by Bombardier Recreational Products (BRP), a Canadian company. The main production facility for Sea-Doo watercraft is located in Valcourt, Quebec, Canada. BRP also has additional manufacturing sites in other countries to meet global demand.
How long can you run a jet ski out of water?
Without running water, for about 30 seconds maximum. With running water, for about five minutes. Make sure to carefully follow the correct procedure for your particular jet ski. Doing this improperly can overheat the engine, melt parts of the exhaust system, damage driveline components, or force water into the engine. If completely cool, most jet skis can be started out of the water and run at idle for 10 seconds with no special procedures needed.
How do you hook up hose to flush kawasaki stx 1100 di jet ski?
To hook up a hose to flush a Kawasaki STX 1100 DI jet ski, first ensure the jet ski is on a level surface and the engine is off. Locate the flush port, typically found near the rear of the jet ski, and remove the cap. Connect a garden hose to the flush port, turn on the water supply, and then start the engine to allow water to flow through the cooling system. Remember to run the engine for a few minutes while the water is on to ensure proper flushing.
What else can you as a dildo?
electric toothbrush that vibrates, running water (e.g. shower or a jet in a pool/spa) a vibrating phone, :)
