0
What else can I help you with?
Mercury Marine where is the impeller located on a 7.5 hp motor?
The water pump impeller on a 7.5 hp Mercury outboard, is located on top of the gearcase, and is driven by the driveshaft.
How can you silence the high frequency sound of your above ground swimming pool filter pump?
If the sound is more like a very loud growl it may be the bearings within the motor. If the motor is less than 1.5 hp or 2.0 hp - replace the motor. You might have to get down next to the pump to determine if it is the motor or the impeller at or right behind the pump pot basket area. If it sounds like the later area it could be that the impeller has debris in it or that may be coming off the shaft. A pool repair tech would know almost immediately. If it is debris in the impeller, that would be the least expensive way to correct. A fairly simple job. Ken
How do you fix a impeller on a Chrysler 25 horsepower outbourd?
This is how to fix the impeller on a Chrysler 25 HP outboard motor. Disconnect the coupling that's on the outside of the leg, flip the housing and twist in impeller.
Can i use 1.5 impeller with a 2 hp motor?
Yes, you can use a 1.5-inch impeller with a 2 HP motor, provided that the motor's specifications align with the system requirements for the impeller. Ensure that the flow rate and head pressure generated by the impeller match the pump's intended application. Additionally, check if the motor can handle the load and any potential increase in operational efficiency. Always consult with a professional or refer to the manufacturer's guidelines to ensure compatibility and optimal performance.
What parts are needed to change a water impeller on 70 hp Chrysler outboard motor?
18-3085 sierra
How do you change impeller on Johnson 70 hp outboard?
Changing the impeller on a Johnson 70 hp outboard motor requires pulling the power head and disconnecting the engine. Once this is done, an open end wrench can be used to first loosen the fitting before removal.
How 2 make 8.0 hp go kart motor faster?
Put a 12 hp motor on it.
How do you get the impeller off the motor super pump 1 hp?
Most pump impellers rotate off in the opposite direction as turning under power. So rotate the impeller anti-clockwise to loosen it. The real trick is to grasp the impeller hard enough to turn it without warping or bending it. There is almost always a screwdriver slot at the other end of the shaft to hold it from rotating as you remove the impeller.
How do you change impeller 5 hp evinrude 1998 2 stoke?
To change the impeller on a 1998 5 HP Evinrude 2-stroke outboard, first ensure the motor is off and disconnect the battery. Remove the lower unit by unscrewing the bolts and gently pulling it away from the engine, being careful not to damage the shift rod. Take off the water pump cover and remove the old impeller, then install the new impeller, ensuring it is oriented correctly. Reassemble the lower unit, making sure all seals are in place, and reconnect the battery before testing.
If the boat outboard motor starts buy stalls when put into gear what is wrong?
what causes a boat motor 40 hp to stall when it is put in gear
Impeller located on 1966 mercury 3.9 hp outboard motor?
The impeller is located in the lower section of the motor near the prop. Take the two nuts off and the lower unit will separate from the top. Remove the O ring and the seal from the long shaft before removing the two nuts from the water pump housing. Good luck removing the impeller itself. I had to cut the soft brass ring with an oscillating tool. A paint can opener also helped in the removal.
How do you replace impeller in 2006 mercury 60 hp bigfoot 4 stroke?
Annually
