answersLogoWhite

0

What else can I help you with?

Related Questions

I Have a 1.0ml Syringe and I need to give my Dog 0.6cc and your Cat 0.14cc of Baytril what marking would that be on the syringe?

For your dog you should fill the syringe to the 0.6 mark on the 1.0 mL syringe. For your cat, you should fill the syringe to halfway between the 0.1 and the 0.2 mark - there are probably smaller dashes between 0.1 and 0.2 to help you with this. If you aren't sure, you should ask your veterinarian to show you on the syringe how full to fill it.


When you fill 1 cc syringe with 1 ml of B12 what number is that on the syringe?

1cc = 1ml. So on the syringe marked in ccs, it should be 1cc.


Why can a syringe suck up water?

A syringe can suck up water because when the plunger is pulled back, it creates a vacuum inside the syringe. This lower pressure causes the water to be drawn into the syringe to equalize the pressure.


How do you mix sucralfate slurry?

Sucralfate is a gastroprotectant that is thought to help with digestive upset by coating the stomach lining to prevent damage to the gastric mucus from high levels of stomach acid. The easiest way to mix sucralfate slurry is to pull the plunger out of the back of a 10 or 30 cc oral syringe, drop the pills into the body of the syringe, place the index finger of your left (non-dominant) hand over the tip of the syringe, fill the syringe halfway or so with water, put the plunger back into the body of the syringe (careful, it's a tight fit) then shake the syringe to dissolve the pills in the water. Then run a large stream of water from the tap and draw the rest of the water needed to make the proper volume into the syringe. Shake again, with your index finger over the opening of the syringe tip, then administer orally. From experience, this is a messy procedure until you get used to the syringe flip in the middle - you can just barely get the seal of the plunger back into the syringe then have to carefully flip the syringe over and push some of the air out to get the plunger fully seated in the syringe again. Then, of course, most animals don't seem to like the taste of sucralfate and are more likely to spit it back out on you rather than swallow it.


Why you cannot squeeze a sealed syringe full of water?

because all the space in the syringe is taken up by water. If you squeeze the syringe it will break.


You have 315 gallons of water how many 28 gallon containers can you fully fill?

11


How much is .3ml in a 1.875ml syringe?

To measure 0.3ml in a 1.875ml syringe, you would fill the syringe up to the 0.3ml mark. This is typically the third smallest mark on the syringe. Make sure to read the measurements carefully to ensure accurate dosing.


What happens if you pour hot water in a beaker?

well the water in the syringe will evaporate and you will see condensation at the top of the syringe.


How many cubic yards of fill for a 24' by 6' round pool?

To fill in this size pool you'll need 100.5 cubic yards of material. If you mean how many gallons of water to fill the pool, you'd need 20,300 gallons of water to fully fill it.


Why you cant squeeze a sealed plastic syringe that is completely full of water?

We can't squeeze a sealed plastic syringe full f water because all the space in the syringe has already been occupied by water and as a result, there is no space left to squeeze. If we attempt to do so , then the syringe will burst or crack.


If you have 386 gallons of water How many 25 gallon containers can you fully fill?

Your answer is 15 386 / 25 = 15.44


How can you dissolve trimethoprim?

The easiest way to dissolve trimethoprim for oral administration is to drop the tablets into a 60cc syringe - pull the plunger out then drop the tablets into the body of the syringe. Put the plunger back in and depress it until the tablets can't rattle around. Fill a small glass with tap water, then pull water into the syringe. Place a fingertip over the tip of the syringe to seal it, then shake the syringe to get the tablets to dissolve. This may take a few minutes, and the resulting paste/gel/liquid is not going to taste good to your pet so expect to need some help restraining him/her to give the medication.