0
Yes, you can carry it with the hammer down on a fully loaded cylinder. Smiths have an internal locking mechanism that prevents discharge of round if it is dropped. I have seen a test where a 16 ounce hammer was used to strike the pistol hammer when it was fully forward on a loaded round. It did not fire. It was struck again, this time hard enough to break the spur off of the revolvers hammer. It still did not fire. The pistol was then cocked and the hammer struck again. It simply will not fire without using the trigger to overcome the internal safety. Here's a simple test you can do yourself...... Unload the pistol. Double check and triple check to make sure it is unloaded. Close the cylinder and cock an EMPTY pistol. Drop a pencil into the barrel, eraser end first. Hold the pistol with the barrel straight up and use another pencil to tap the trigger. When the trigger releases the hammer, watch the pencil. It doesn't move because of the internal lock. Now, remove the pencil and cock it again. Reinsert the pencil, hold it in a vertical position and use your finger to depress the trigger. The firing pin will strike the pencil eraser and move the pencil because the internal lock was overcome.
What else can I help you with?
Can a double action pistol load the first round into an empty chamber one the first pull or does a round have to be loaded first?
A double action pistol does not load itself. Double action means that the hammer does not have to be cocked separately- pulling the trigger will make the hammer rise and fall- but you still have to chamber a round of ammunition first.
What is loaded into a gun?
A round is loaded into a gun. The gun is then cocked and then fired.
Is it illegal to carry a handgun with a chambered round in Oregon?
If you are in a place like Portland or Oregon City that restricts loaded carry by people who do not have concealed handgun licenses, you may not have a loaded firearm in your vehicle. Furthermore, if it is a handgun, it must be carried openly or "not readily accessible."
What is the safe way to tell if a firearm is loaded?
Pointing the barrel in a safe direction and with your finger away from the trigger or hammer (if so equipped) carefully open the breech or cylinder of the weapon to see if a round is chambered or not.
What does the hammer of the pistol do?
Typically, the hammer strikes the firing pin which may fire a round, if there is a fresh round in the chamber. In older pistols, the hammer can hit the primer directly (the tip of the hammer has the firing pin on the end).
What size is the 9MM round?
The 9mm round in loaded with a bullet diameter of .356"in.
What are the five M9 service pistol alert carry?
The five M9 service pistol alert carry modes are: Condition 1: Round in the chamber, safety engaged, ready to fire. Condition 2: Round in the chamber, hammer down, safety engaged. Condition 3: Magazine loaded, chamber empty, safety engaged. Condition 4: Unloaded with no magazine, safety engaged. Condition 5: Unloaded with no magazine, safety off. These modes dictate how the firearm is carried and its readiness for use in various situations.
Is it safe to use the P round in an early model 36 .38 Spl for concealed carry only?
Not recommended.
How many rounds does a springfield model 187 hold?
The Springfield Model 187, specifically the Springfield 1873, typically has a magazine capacity of one round, as it is a single-shot rifle. However, if you are referring to the Springfield Model 1873 Trapdoor, it is also designed for single-shot loading. Each round must be manually loaded into the chamber after firing.
Do pre 64 Winchester model 94 rifles not have safeties?
the model 1894 winchesters of that time did not have what you would consider a mechanical safety,( a button or wing type safety) there safety was a half cock,that is once a round was levered into the breech and the hammer was all the way back you had to safely hold on to the hammer with your finger hand squeeze the trigger to ease the hammer forward then thumb the hammer back until it clicked in the half cock position.
What determines if a rifle is fully loaded if the bullet is not chambered in the breech or rear of the barrel and if the bolt is open could this rifle fully loaded or not fully loaded?
What you are describing could be a rifle that is not loaded, partially loaded or fully loaded, but, does not have a round chambered.
What year would you put a model 38 22 pump with a round barrel hammerless slide safety where hammer would be?
Can't be done without knowing who made it.
