Most newer generation Glocks can shoot the .357sig in a .40S&W with a simple barrel change. You can use the same magazines. The same is true for shooting .40 in a .357 Sig. This is true with Sig Sauer guns as well. I have a Glock 23 (.40 S&W). I simple install the Glock 32 barrel (.357 Sig) which I purchased for $100. I can shoot .357 sig out of the same gun. The magazines (at least for Glock) for the .40 and .357 sig are interchangeable. You CANNOT safely shoot a .40 out of a .357 sig barrel or vice versa. A barrel swap is required. If you load a .357 Sig round into a barrel chambered in .40 S&W, it could fire, but it would probably cause damage to the gun and won't be accurate. .357 Sig has better "terminal performance" than the .40, but the .40 shells cost less which translates into more practice for the same $$$ with the .40, and better self defense with the .357.
No
No, the bullet will not seat.
No.
You can from some, but they have to be designed to shoot both.
The short answer is no. You should not (and normally can't) fire any ammo in a gun other than what it is specifically designed to shoot. There are some exceptions, such as, you can fire 38 special in a gun designed for .357 magnum.
IF a rifle is chambered in caliber .35y magnum, yes. Among others, Marlin made a lever action .357 magnum rifle.
Generally speaking, no. You can only fire the caliber for which the gun is chambered. There are some exceptions, but not many.
No. Standard ammunition in the correct caliber for the gun. However, ONE of those calibers is the .357 SIG auto, and other .357 cartridges do not interchange with that.
NO, a 38 Special is actually .357 caliber. NO, a 38 Special is actually .357 caliber. A 38 special is NOT a 357 magnum. Both bullet heads are about .357 in diameter. The difference between the 38 and 357 is the length of the brass case. The 357 brass case is a bit longer then the 38 special case, and the gun powder load is a bit higher then the 38 special load...... Further, you can shoot a 38 special case in the 357 magnum revolver, however, you cannot fire a 357 magnum round in the 38 special. The 38 special cylinder is too short for the 357 round......
If you mean a .40 caliber bullet in a .32 caliber gun- no. The bullet would be 8 thousandths of inch too large to fit in the gun. Caliber refers to the diameter of the bullet, so a .40 caliber bullet is ABOUT .40 inches across, and a .32 bullet ABOUT .32 inches across.
No. You should never try to load or fire any ammo into a gun other than what it is designed to fire. A .44 caliber gun is designed to fire .44 caliber ammo.
Yes and no. The. 40 S&W is not interchangeable with the .357 Magnum, if that's what you had in mind. Most .357 Sig pistols can, however, but a .40 barrel will have to be dropped in in place of the .357 Sig barrel.