answersLogoWhite

0

A 15 mm socket is one of the most common used on modern cars. If you don't have one,go and buy a decent socket set.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What size hex bolt on brake caliper on 2005 grand caravan?

For the front I believe a 15/16 socket will work. The rear I used a 7mm Allen wrench


What size wrench do you use to drain the oil on a 2007 Chevy impala?

Probably about a 15 millimeter wrench or socket.


What wrench fits a 24mm hex head?

A 24mm wrench is the only size that will fit properly. It's a bit over 15/16 so you can't use that. -Possibly a 31/32 wrench, but that's fairly rare.


What tools to pull starter on 99 sable?

A 15mm and a 10mm socket, socket handle and a 15 mm box wrench (preferably Gear Wrench) the bolts are usually very tight. - 2 bolts from tranny side hold it. Don't forget to remove battery cables first !


What is the right socket or wrench to remove the starter bolts on a Detroit Diesel 353?

11/16th, 12 point for the back bolt / use a 3/8 drive wrench along with extensions sorry should be 9/16 , 12 point socket , the two easy bolts are 15/16 inch


How do you get the centrifugal clutch nut off your 2007 Honda 250 recon?

15\16 socket and a impact wrench and a ratchet strap. It has left handsed threads.


How do you release the tension on the serpentine belt on a 93 Tempo 2.3l?

it is either a 15 mm or 18 mm socket or wrench and just swing it, it will only turn one way and it will release the tension on the belt


How do you change the top motor mount on 1991 Buick Regal Limited?

If its a mount referred to as a "dog bone", then replaceing it is really simple. You will need a 13 and 15 MM deep well socket, and a 13 and 15 MM wrench. With the motor in nuetral, the wheels chocked, and the parking brake set, you can easily wrench off the 2 bolts that hold the mount on.


Where is the fuel filter on a 1996 Toyota T-100?

The filter is located on the frame of the truck under the driver's door. A 10mm wrench or socket is needed to loosen the clamp and a 15 mm and 19 mm open end wrench is needed to disconnect the tubing from the filter. New filter is about $15.00


How do you change the starter on a 1990 Pontiac transport van?

a 15 socket can be used on one of the bolts but you will need a wrench to get at the other one as there is no room to get a wrachet up behind the bar that goes along there just simply put the wrench over the top of the bar and u can get at it from there as for the 15 scokey it is straight forward and by the way the wrench is a 15 also ...pretty simple.. Is it necessary to remove the oil pressure switch, the oil filter and the engine stabilizer bar, (and even the fan and housing)this is a very ambiguous answer above


When was Hex Hector born?

Hex Hector was born on April 15, 1965, in Manhattan, New York City, New York, USA.


What is t-15 island wrench?

your service sucks!