answersLogoWhite

0

As with most fuses for the Mk 80 series bombs, the fuze has a substantial explosive booster (about 1.5 ounces of tetryl) capable of causing close range casualties on its own. Arming times are in-flight selectable, but the functioning delay must be set during weapon assembly. There are three arming times (2.6, 5.5, and 10.0 seconds) and four functioning delay settings (10, 25, and 60 milliseconds, and instantaneous). Only 2.6/60, 2.6/25, 2.6/10, and 2.6/inst high drag arm/delay switch positions are authorized for Navy/Marine Corps use. The low drag arm time switch should always be in the X position. The low drag arm time rotary switch is positioned at X for shipping, storage, and all FFCS (fuze function control set) use.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Why is your blinkers and hazards not working?

It may be a bad fuse.... Try that.


Why doesn't the blinkers on your 1997 Chevy S-10 blazer work if all the bulb and hazards work?

The blinker is on a separate fuse from the hazard lights. You probably need a fuse just for your directionals. It is located right next to the fuse for the hazards.


99 ford e-150 the hazards and turn signals stopped working suddenly it isn't the fuse for the turn signals or Hazards as i checked what else could it be?

your fuse is to strong try a lower fuse or some other one is wrong sending too match power that why to blows, or is your headlight cracked?


What is buzzing noise coming from turn signal fuse on 93 tracker?

there is a constant buzzing from fuse box until signal or hazards are activated or until turn signal fuse is pulled


Why do your turn signals and hazards not working?

fuse or blub is out or blown, or wiring is bad, or the relay is bad.


Why do blinkers reverse light and hazards not work on 95 accent?

Blinkers, Reverses lights and Hazards are all wired into the same fuse. When a short occurs in one of the components all of the lights will cease to function. The fuse should be checked to see if they are in working condition.


How do I remove a fuse from a fuse box?

To remove a fuse from a fuse box, locate the specific fuse you want to remove, use a fuse puller tool or a pair of needle-nose pliers to grip the fuse, and gently pull it out of the fuse box. Make sure to disconnect power before removing the fuse to avoid any electrical hazards.


Brake lights and hazards don't work 1991 jeep Cherokee?

replace fuse and hazard flasher


Why does your hazard lights work and your turn signal light not work?

Two separate circuits in most vehicles. You have a fuse and a flasher for the hazards and you have a separate fuse and flasher for the signals.


Where is flasher fuse located in 91 Chrysler lebaron?

Indicators.. fuse 6 Hazards Flasher fuse 28 Fuse box should be under the dash drivers side panel says fuse access.. if its a relay.. relays are behind and above fuse box attached to body panel.. PIA to get to the relays


The turn signals and hazards on my 1998 Hyundai accent have stopped working. Fuse is fine. Can anyone suggest something to try?

Try Replacing the Blubs since the Fuse is Fine


Where is the fuses for the horn and hazards lights in a 1995 Toyota corolla?

Horn fuse in located in the fuse box in the motor and the lights are located in the driver side in the bottom on the left side