answersLogoWhite

0

What else can I help you with?

Related Questions

What size drill bit is 5.105 mm?

5.105 is 0.201 inch , or #7 on drill gauge. Both are common drill bits.


Does the 1998 Chevy Cavalier have a fuse for the anti-theft light or device?

No, this is controlled by the BCM. An easy remedy is to take a 1/32" drill bit and drill into the gauge cluster into the light if it annoys you that much.


What tools have 5 letters?

drill ruler plane lathe clamp brush cramp lazer snips auger bevel gauge knife


What will happen if a wire that is plugged in heats up?

its casing will dry out, crack and catch fire, or it will crack off and cause arking, which can cause a fire... ultimately, check the gauge size of the circuit and make sure it corresponds to the proper amperage of breaker, if this is all good, you need a bigger cord(the gauge size must be sufficient for the intended tool/device.. a drill that has a 16 amp rating needs a 12 gauge cord whereas a 12 amp drill needs only a 14 gauge cord.


How do you prime a 440 engine?

pull the distriburetor out and get a primer shaft that will fit a Chrysler product from summit racing and put it in a 1/2 " drill and put the drill in reverse and spin away until you get oil pressure on your instrument panel gauge or if the engine isn't in the car or you don't have a oil gauge you can pull a valve cover off and when oil starts lubricating the valve train your primed.


What size drill bit for 8 gauge screw?

0.31 inchANS 2 - or, in fractions, 5/16 ths


What is drill machnie?

A drill machine can mean a hand held electric drill, or a bench drill press or a pillar drill.


Why is the voltage at the end of a long extension lead used with an electric drill less than the mains supply voltage?

Resistance in the length of wire that makes up the extension cord causes voltage to drop. But it needn't be a problem with the right extension cord. For an electric drill, up to a 25 foot cord of 16 gauge wire will cause a voltage drop so small as to be negligible. For 50 feet, switch to a 14 gauge cord. For heavier power tools (circular saw in particular) you should use a 14 gauge extension from the get-go.


Where exactly should you drill through your fire wall to run a two gauge wire through it to the battery rather on passenger side?

should just cut one of the boots that have wires going threw it already. That should work better. try not to drill anything threw the fire wall its there for a reason.


How big should you drill your electric chase?

Drill using a 280 degree drill by samsung drill and drill about 5cm by 5 cm


How do you put a drill bit in a drill?

To put a drill bit in a drill, you typically loosen the chuck, insert the drill bit into the chuck, and then tighten the chuck securely to hold the drill bit in place.


How do you drill people?

With your drill