Either drill lock out or try removing rear seat back for access
You have to open the trunk lid, under the lock on the inside you will find a screw, remove the screw and the lock retaining clip, pull the lock out. If you can not open the trunk lid, drill the lock center out, and you should be able to open with a screw driver.
drill the lock and push in, lift open the trunk door
Firstly, is it yours? If not, then you can't. Contact the manufacturer and see if you can get a replacement key. If not, call a locksmith. They can usually pick the lock open. If not, they can also drill it open. If they won't drill it, look up instructions on how to drill out a lock. If that's not possible, see if it can be sawed open. If not, hire a company to blast it open. If all else fails, re-evaluate the value of the item inside the safe. Is it really that valuable?
Without a key or a lock smith the most common way is to drill the lock out. Start with a 1/4 bit and drill in the center of the key hole. Keep moving to larger bits till the lock tumblers break out, then you can install a new lock.
Try contacting a locksmith. If you can't get the door open at all, they will have to drill out the lock and replace it.
all you can do is drill it out and use a grinder as well takes around a hour to do big job
drill out the centre of the lock and then use a screwdriver like a key. once open you will be able to remove the old lock and replace it with a new one that has a key.
I've had to open a few when people lose their keys. Generally it is a 3 or 5 lever lock and by checking the workings on another-that's it the one you keep in the back of the van- you can sort out where to drill through the door and lock to get access to the levers, which you can then hook up with a screwdriver. Another way is to cut through the stile and just allow the door to open
Drill through the lock. There is a "gear" on the back of the lock. Try not to drill through it. After you drill through the lock you can use a screwdriver to turn that gear to the right position (RUN or ACC )depending on what kind of car you have. Then all you have to do is remove the steering wheel and mis. parts to get to a screw that holds the ignition switch in. Then remove the lock and install the new one.
Low angle makes it three drill lock system.
Replace it. There about 24.00, you don't need a key to replace it. and if you drill it you have to replace it,so save your time. If your trying to rob a house you can get a pick set at a lock smith.