0
The Weaver scope mount that fits the Marlin Model 780 .22 bolt action rifle is typically the Weaver 1-Piece Base, specifically designed for Marlin rifles. Ensure you check the model compatibility and specifications to confirm a proper fit. Additionally, it’s always a good idea to consult the manufacturer's guidelines or a knowledgeable dealer for precise recommendations.
What else can I help you with?
Which weaver scope mount fits a marlin model 80 22 bolt action?
A weaver number 2 base and your choice of weaver side mount rings, midway has both. Total cost for both pieces is around $50.
What kind of scope rings do you need to mount a scope on a model 512 slugmaster bolt action shotgun you have the side plate?
Hello: Weaver offers a scope base for the Marlin Model 512 Slugmaster, contact Weaver for a complete package. Thanks side scope mount (Weaver 10M)
What weaver scope mount fit a JC Higgins Model 30?
A JC Higgins Model 30 typically requires a Weaver scope mount that is designed for a specific type of action, often a Mauser or similar. The Weaver 1-inch scope rings are commonly used, along with a base that fits the receiver of the rifle. It’s essential to verify the specific model of the Model 30, as there may be slight variations in the mounting system. For the best fit, consult the manufacturer's specifications or a knowledgeable gunsmith.
Can you put a raised scope on your 30-30 marlin model 336?
Yes.Most marlin model 336 rifles have been drilled and tapped for a scope mount on top of the reciever.
You are looking for a scope mount that will fit a JC Higgins bolt action 22 caliber The model number is 10516?
I have a J. C. Higgins model 10516 with the original 4X scope . The scope mount says J.C. Higgins 4X PATD , MFD by W.R. Weaver Co. El Paso TX. IT also has N3 stamped on the mount. Hope this helps.
Where can you find a scope mount for a Stevens model 87a?
Scope mounts that mount on the left side of the receiver using the four screw holes are available from Weaver.
What is a weaver base mount on a gun?
Mount for a scope.
Where can you buy a silver scope mount for a model 336 XLR Marlin?
Possibilities... www.Factorysound.com or www.Jaycar.com hope that has been a help...
Where can you find a scope mount for bolt action 3030 Stevens model 325a?
you can get that mount at mid way
What scope mount would you need for a Springfield model 87-A?
That will take a Weaver #12 base for both front and rear or a Weaver #2 sidemount. Weaver notes that the rifle will need to be drilled and tapped. See http://www.weaver-mounts.com/mountcharts/default.aspx
What kind of base mounts are needed for a JC Higgins 22 cal rifle Model 10313 that has two pairs of tapped screw holes on the side of the bolt housing and chamber?
That gun was made by Marlin for Sears, and those holes are not factory. Someone has drilled and tapped it for (probably) a Weaver side-mount base.
Can I mount a weaver on a dovetail mount?
Yes, you can mount a weaver (or Picatinny) rail accessory on a dovetail mount, but you will need an adapter or specific rings designed to fit both the dovetail and weaver dimensions. Dovetail mounts typically have different width and groove specifications compared to weaver rails, so ensure compatibility before attempting to mount. Always check the manufacturer's guidelines for both the mount and the accessory to ensure a secure fit.
