you could check for oil pressure , could be a fault in the oil pressure sensor that is holding the pump out. i have seen some of these trucks have a loose ground wire near the fuel pump also
cutlikeabuffalo oil pressure? its not running yet!!! electric fuel pump has nothing to do with oil pressure before start-up. check for fuel supply to throttle body or rails. a fuel pressure test will determine sufficient supply,u could also just loosen a fitting to check for presence of fuel being pumped up to engine. restriction could also be due to clogged inline filter or blockage at pickup tube inside tank. This would more likely generate a rough running or low power condition , however it "should" still fire. Check for power to pump @ connector 3pin near driver side rear of truck wire loom going from frame rail to pump at top of fuel tank, yes it could be a poor ground. Ground wire from pump side of connector to frame. If no power work forward from there. Check breaker/ fuse/ relay and wiring. a point to point voltage drop test would be the best way to locate hidden resistance in the wiring , a break, short ,or corrosion. If good power and no fuel, either pump is not running, (u can usually hear it work when key is first turned on for a few seconds) or there is a restriction.
Have you checked the steering wheel?
the motor is probably seased......
It has to be checked out and find out what is wrong with it.
Try changing the brake light switch (located on the brake pedal, by the steering column) under the dash.
All COMPONANTS have been checked and or changed. It has to be in the motherboard, possibly an issue with the PCI/ISA slot.
Instead changing lens, which is not an usual procedure, it would be advantageous to purchase a new camera that has the kind of lens you are looking for. Normally, lens is a part of the camera that can't be changed, except on expensive models. In this case, changing the lens is an easy procedure that can be checked on the user manual.
Have you checked for fuel and spark? Fuel pumps ad burnt ignition rotors are very commen on these vehicles
Definitely a timing chain, I checked the parts page on GM
tolerant... ive checked and double checked and that's it, need anything else?
"fuel pump relay contacts dirty or relay bad" I have checked contacts and I have changed the relay....Do you know of anything else?
If you are changing the rims yes you will need it checked. If you are just changing over a tyre it isn't essential and most probably will still be balanced.
Perhaps starter is weak. Have it tested for load and drag