Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, whether direct current [DC], or alternating current [AC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or repeatedly "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, that is to protect the conductors and components of the circuit which it serves.
The proper "fix" for this issue is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.
Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an oversized fuse would almost guarantee damage to the wiring and the probability of an electrical system fire.
can a chevy truck with a 350 engine with a tbi cause detonation and pre- ignition?
Ignition wiring diagram
1,8,5,3,6,5,7,2
no
i need the ignition timing for 88 chevy 5.7 ... 350 motor i had the truck on 4 but still bad don t run good
Either the bulb has too many watts, or there is a fault in your wiring.
How do you program a an ignition key for 2008 Chevy truck
That is the ignition coil.
call a locksmith
High-powered explosives.
That truck should have electronic ignition, no points.
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.