The tile was put in place after it was functional, you should be able to remove it with out shutting down the water supply.
That is not necessary.
How many length between two sprinkler2 in the room building. How many lenght between two sprinklers at the ceiling. 3 meters
open the bonet and unscrew the cover off then unscrew the bulb and replace and then put it all back together
just replace it. . . this might mean digging around the head, cutting the line on both sides and replacing the line and head with new ones
do you mean un-clog a shower head? u need to unscrew the head and clean out the screen filter and then replace the head again
It is usually engraved on either the top of the reflector or the side of the sprinkler head.
unscrew it from the speedometer head under the dash and unscrew it from the tranny and pull the old one out and install the new cable.
Open head sprinkler Closed Head Sprinkler (1874)
My edcated Guess would be to open the hood, unscrew them and replace them.
25-150 gallons per minute is standard depending on the type of sprinkler head. Residential sprinklers will be closer to 25. That flow is for a SINGLE sprinkler head. Typically the fire will be extinguished by just activating one sprinkler head.
Under the front of the truck on the diff. or hog head,This is where the actuator is located it has two wires on it and screws into the diff. or hog head,You will need to unplug the wire connector and then unscrew the actuator and replace it.
Aerator in shower head is plugged up. Unscrew head, clean it out, and replace. Make sure you have teflon tape on hand for the treads on the shower arm when putting the head back on.