0
Do you have to remove the gas tank in order to replace the canister vent shut valve?
Quinnbaity
Absolutely not. It's located on the left side of the vehicle near the front tire.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the canister purge valve located on 1996 4.0l aerostar?
Canister purge valve is located under the air cleaner assembly, remove the aircleaner and the airintake hose, remove air filter, underneath in air cleaner housing are 2 7/16 nuts,remove and take housing out. canister is underneath. valve closes to canister is the purge solenoid.
How do you remove and replace an evap vent solenoid on a 1996 GMC Jimmy 4x4?
also referred to as the Vapor Canister Purge Valve and is in\on the charcoal evaporator canister. its under the floor above the spare tire location, locate the charcoal canister on the front of the gas tank and trace the vent line to the vent valve.
Where is Evap Canister located on 1998 Lumina?
My canister was in the Left Rear fender well. Right behind the taillight. You must jack the car up, remove the LR wheel, then using your 4 foot long left arm, feel behind the tail light. Most often the hoses are dry and loose fitting. Replace them if you can. You should also replace the valve on top of the canister because once you replace the canister, you will probably never visit this area of your car again. There is a bolt that holds the canister to the inside of the fender well. You should unplug the electrical connector on the valve on top of the canister, then disconnect the hoses that connect to the top of the canister. Once you have removed all these, you can remove the bolt holding the canister, and bring the canister out into the sunlight. Replace all the hoses if you can, then install your new $85.00 canister back in place and connect the hoses and electrical plug. Because of its location, this can be a very frustrating job. You need the hands of a child, on 4 foot arms, and double joints. Paul
Where is the Lumina evap canister?
On the 1998 Lumina LTV you will find the Evaporative Canister under the car, between the gas tank and spare tire well that protrudes from the bottom of the trunk. Easy to replace. Costs between $65 and $120. If any of the lines are cracked you should replace them with new ones if you can. If you have already replaced the Evaporative Canister Purge Valve located on the top front of the engine, next to the valve cover, and you are still getting an OBD code P1441 the charcoal in the canister may be breaking down and getting sucked into your new purge valve. It is a good practice to replace both the purge valve and the canister at the same time if you can afford to. Paul
Where is the vapor canister vent valve located on 2006 Rendezvous?
The canister vent valve is located near the fuel tank. The canister purge valve is located on the engine.
How do you remove concrete from a gas valve?
Your kidding me right; replace the valve.
Where is the canister purge valve located for a Chevy venture?
where is the canister purge valve located on a 03 chevy venture
How to replace vent control valve and canister on a 2001 Nissan xterra?
drop the spare tire,under neath the spare tire the canister is right there,undo 3 12mm bolts and the canister will come down,then theres 2 10mm that hold the vent control valve in there undo the vapor lines and the vent valve connector and reinstall new one
How do you replace the valve lifters on a cavalier?
To replace the valve lifters on a Cavalier, remove the intake manifold, valve covers and rocker arms. Remove the heads of the lifters using needle-nose pliers.
What is EVAP code p0443 in 97 Ford Explorer?
P0443 - EVAP control system CANISTER PURGE VALVE CIRCUIT MALFUNCTION - VPWR circuit open - Evap canister purge valve circuit shorted to ground - damaged EVAP canister purge valve - EVAP canister purge valve circuit open - EVAP canister purge valve circuit shorted to VPWR - damaged PCM
Where is the Canister purge valve on a 2001 sunfire?
Cannot locate canister purge valve on a 2001 pontiac sunfire 2.2
How do you remove and replace the AC expansion valve on a 1996 S10 6-cylinder Chevy Blazer?
Remove the bottom hose from the evaporater at the firewall, pull out the expansion valve, i highly recommend flushing out the system to remove excess sludge. Replace the valve and the hose.
