You can either pull the engine are the transmission. But 1 are the other has to be removed to change the rear main seal. Your choice.
Sure... you'll just have to remove the transmission & flywheel.
how do you change a rear main seal in a Chevy 350 motor
You have to remove the main bolts from both side motor mounts and lift motor up high enough to clear .
Remove transmission and replace the rear main seal
Absolutely!
the main motor mount, the one I am looking for, goes on top of the engine at the pooley side
The rear main seal is located on the moter between the transmission you have to pull motor or trans to change it the seel is on that shaft that slides into the transmission saft
The timing sequence marks, for your 1994 Toyota Camry 2.4 liter engine, are located on the main front pulley. Begin the timing sequence with the number one position.
no special order, torque is 70 ft. lbs.
you need to purchase stick on beam deflectors from motor factors ....PS
Remove the trasnsmission and you can then replace the seal.
first change the blower resistors first , way easier and #1 cause of motor dead. after main switch and fuse. the procedure is long and hard. you need to go to the library and print out the chiltons e-sources on that .