There should be 3 bolts on the inside of the tailgate. Remove these. The black faceplate around the handle will be loose. Push down and tilt out, away from the tailgate. This will expose two plastic tabs. Push down on each tab with a screwdriver to remove the pressure and pull the handle clear. There are two plastic posts on the bottom that fit into holes but they don't require anything special to pop out. The hardest part is to remove the faceplate without breaking the two tabs. Youl'll now see a rod on either side of the handle that is held in place by plastic sleeves (no wonder it broke). I used two cable ties (you can get these at any electronics or hardware store) to secure the rod on each side by looping one over the rod and the other through this one and around the handle. Sounds complicated but it will make sense once you open it up and take a look. I understand that GMC wants you to replace the entire assembly rather than just the two plastic pieces so cable ties are a cheap alternative.
The tailgate latch comes off with the cable. It is one piece.
The latch assembly and cable is one piece.
Unfortunally you can't replace just the cables. They come with the latch assembly and there is a left and right.
the glass door will not latch on to the tailgate of the jeep
how can i repair a 94 chevy k1500 tailgate latch. cannot open gate
The left or right tailgate cable comes as an assembly that includes the left or right side tailgate latch.
You need to order the part(s) first, which you can do at your local Toyota dealership or at an auto parts store. Then, you simply disassemble the tailgate, remove the defective latch component, and put in the new part, and then reassemble the tailgate.
lmc truck, there on the web
I assume you want to change the oil in your truck. To do that, what you need to do is disregard all that anyone has told you up until now. The easy way to do it is to drop the tailgate and locate the drain plug located right next to the tailgate latch on the drivers side.
open tailgate and there will be two screws. upper and lower. upper by the tailgate latch.
put a screwdriver in the latch pull the handle and apply pressure to the screw driver should pop the latch open
use a flat head screwdriver to open the mechanism that is not workin put it in and push backward toward the tailgate