to reset this you do the following:
Put the key into the "run" position, without starting the car, but with the fan, radio, lights, etc. running.
once in that position, full depress and release the accelerator pedal 3 times in a row, you will see the oil change light flash a few times on the dash, and you're done!
start up the car, and the light should no longer be lit.
Instructions on how to do this can also be found in the manual, just look for "change oil light" in the index in the back, and it gives you detailed instructions on how to do this.
Yes, with an OBD II reader. Disconnecting the battery won't reset it.
If you're talking about a Ford-style fuel cutoff switch... there isn't one.
Push the odometer trip reset till you get to "oil" then press and hold down till it reads "100"
Turn on the ignition (switch). Depress and release the accelerator pedal three times within five - ten seconds. Turn off the ignition. Start the car; the change oil light should only light up during the self test. The mileage interval since the last reset will activate the change oil light. If you want to use the change oil light as your reminder for service, repeat this process immediately after an oil change.
reset swith is usually under floor mat high up under dashboard on driver side GM vehicles do not use inertia/reset switches.
Have the problem repaired and they will reset the light. If you DIY then disconnect the negative battery cable for 5 minutes. If that does not reset the light you will have to have it reset with an OBD2 scan tool.
You need an auto locksmith-look for one that's mobile on Craigs under services.
hold the engine reset button in until it resets
Reset the change oil light on Mazda 3
Your owners manual should tell you how to reset the light.
how do you reset change the oil light in a 2004 alero?
on the drivers side there is a fuse panel on the dash. there you need to press the reset button once and then your change oil light will blink. then you want to press it again and the low tire pressure light will blink hold the reset button until it beeps and then let go and then press the reset button again and the light should disappear. Hope this helps!