The newer cars will have a blinging light on the dash and come with a control fob for your key chain. If it was original equipment, you could get your VIN number and contact a dealership for the make of your car. I would think any type of security system would give you some type of controler for it, so you could turn it on and off. Hope this helps.
it depends on the what system you are talking about and the car it is going in, you have the car alarm system, remote start system, alarm system, and car stereo system, and every car is different
my alarm system keep disable my car how do I reset or disable this alarm system
Yes you can put an alarm on a car with no power locks, you can even buy central locking system that you can fit to a car with no power locking system that will connect up to the alarm system. Danny from Bee Mech Mobile Mechanics Find me at www.beemech.com.au
In an alarm condition, the siren output is a steady output, rather than a pulsed one. To connect the car alarm system to the car horn, simply hook it up with the relay to switch the horn power.
One can purchase a car alarm at a store that sells car accessories. The dealership where one purchased the car might also be a good source for a car alarm.
There are several electrical wiring options available for a car alarm system. A person can have their car alarm wired so it will go off if anyone touches it. Also, a car can be wired to set an alarm off is anyone tries to open a door.
If you deactivate the horn your car will not pass the state inspection next time. In order to get rid of the problem you have to reprogram the alarm system. For that you have to find out which alarm system you have. If you have an aftermarket alarm system then you can check the alarm system manufacture website for instructions. If the alarm system was installed by the manufacture you have to contact a local car dealer (the same manufacture of course).
YesYes
Remove the fuse.
You will need to get a wiring diagram of the alarm system.There is no way to tell what wires were cut or changed when the car was hot wired.
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
It really depends on how the alarm is wired into the car. If it is wired into the ignition system the yes it will keep the car from starting if triggered.