This is the calculation for how much static pressure shall be created by the pump to flow the water in chiller loop or for the pump to flow the water for cooling tower cycle.
Very carefully
it is the max vertical height upto which pump can supply the water.
It might be less than (10.33/sp. gravity) m
A condensation pump carries away water produced from latent water vapor in air conditioners, refrigeration units, steam systems and other HVAC operations.
Heating, ventilating, air conditioning systems (HVAC) most often use a refrigerant for cooling and a furnace or heat pump for heating. Both heating and cooling are directed through the same ventilation network.
When a pump is pumping water from a level that is below the pump it is called suction head. If the water to be pumped is at a level above the pump, it is positive head. The pump maybe pumping from the base of a tank to a higher level such as an elevated tank or it may be pulling water from a tank that is below the pump. The distance from the center of the pump to the top of the water level would be the foot of head. It takes 2.31 feet to make 1 P.S.I. So if it is 10 feet from the center line of the pump to the water level, you would have about 4.33 P.S.I. of head.
HVAC Software, HVAC Load Calculation Software, Energy Design Systems, HVAC
An HVAC pump can be purchased at a retailer which stocks equipment for heating and cooling homes and other buildings. Pumps range in price from inexpensive to very expensive depending on the pump's features.
Call an HVAC technician
Fist you will need to have a manual J load calculation performed on your home to properly size the equipment . Then a reputable technician can tell you if the unit is correct for your application . Tom H. HVAC professional , New Orleans
tell me the procedure of pump out in split unit HVAC
343. In-head calculation.
HVAC in an all-encompassing expression for Heating, Ventilation, and Air Conditioning. Your contractor is referring to the technology built into your home that makes these things possible.
You will have a flood PLUS your furnace will rust out. Can you hear it run? what happens when you fill the pump with water? Is there electric power to the pump?
The ratio between the energy efficiency of pumps and pump uses the energy that does. Pump efficiency is determined by the manufacturer. In the calculation of pump efficiency is 70%.
This question depends on alot of things. You should find a reliable HVAC company to run a manual j (sizing of hvac equipment) load calculation on your home. there are so many things that take part in sizing an a/c unit that if not done propperly than you could serious problems.
it is the max vertical height upto which pump can supply the water.
HVAC Load Calculation is a formula used by a contractor salesmen that determines the proper tonnage size of heating and cooling systems to be installed in Residential or Commercial applications. The formula is used to calculate the total cooling and heating BTU'S (British Thermal Units) for the proper values of determining the correct tonnage to be installed in HVAC applications. Tonnage is the size of the HVAC system. Without this Load calculation the wrong tonnage could be installed and it causing to much humidity in the summer in cooling season and not enough heating in the winter season. Also the HVAC system may never stop running to reach the proper temperature that the thermostat is set for. Thus causing high electricity out of pocket cost.