remove the two 10mm nuts. dissconnnect the coolant level sensor plug and remove coolant hose's
It is in the coolant expansion tank Problems with this sensor are common as they are pourous and take up coolant, eventually sinking and bringing on the coolant check light. You most likely will need to change the coolant expansion tank to cure the problem as it is usually sold as a unit. Kev
The RX8 takes standard anti-freeze.
The RX8 has a common problem with the coolant level sensor in the expansion tank. Unfortunately the sensor is part of the tank and so the whole unit needs to be replaced, a fairly easy job to do!
how do i remove the starter motor Mazda rx8
You can't. It is part of the fuel pump.
The 2011 version of the Mazda RX8 was the last model produced by Mazda. Models of the Mazda RX8 are still available for purchase and can be found online.
WE CAN GET MAZDA RX8 IN GTA SAN ANDREAS By installing rx8 mod
wher can you find the chassis number of mazda rx8
Rx8, but not by too much.
The coolant sensor is a common fault which causes this issue. You will need to replace the coolant expansion tank as the coolant sensor is built into the bottom of the unit.
how good were they Nazda RX8 2004
go under the car and locate the radiator in the left side you will see a small plastic bolt remove it and the the coolant will be out after its empty put it back and done.