I have a 98 Sebring LX Coupe so I am not sure if this applies to you but I just had both lower ball joints bad, and both were covered by a Lifetime warranty by Chrysler. I had it done at the dealer. I was amazed. It didn't cost me a dime so it is worth looking into to see if your model is included in this.
Yes
There are two on the front, and two on the rear.There are two on the front, and two on the rear.
Yes
Yes.
It has two shafts that have an inner and outer joint each. That totals four CV joints.
No the axle shafts use CV joints.No the axle shafts use CV joints.
Both of the front wheels on my 99 Sebring have fallen off in the last year. Caused by failed lower ball joints.
What year, if it has upper it has to be pre 1989
Replace the whole sway bar link.
On the Chrysler there are no such things as "CV joints". There are however "U joints". To remove them you would have to drop the driveshaft and have them pressed out by a machine shop.
Just spray it with Teflon or better yet silicone spray- mine was squeaking something terrible -- a few sprays at the joints and the stripping edge did the trick. Hope this helps
Call your local Chrysler dealer with the VIN and they will check your recall status.