Your Aurora has 2 Crankshaft positioning sensors.
I just replaced both of the CPS on my 2003 Aurora on 6/2/2012. They are located under the car, near the oil filter. If you raise the car, laying down looking up at the oil filter- The sensors will be to the left of it. To me, this was not an easy fix. The hardest part was getting the connectors off. I took off the oil pressure sensor, to allow more space to work. The sensors are held in by one #10 socket.
If those sensor were located right under the hood.. this would be a 5 minute job. Its the location of the sensors that's a pain in the a$$.
Good Luck.
The length of time it takes to change a crankshaft position sensor on this car depends on the people working on it. It can take 1-5 hours depending on the person(s) making the change.
Where is the speed sensor located on a 1997 Oldsmobile Aurora
change bulbs in gear selector of 2001 oldsmobile aurora
Remove the intake manifold. The starter is underneath.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
hold the engine reset button in until it resets
7 1/2 qts. with filter change.
Probably every 50K should be sufficient
Hold on/off button and reset simultaneously for 3 secs
you need to change the window regulator
How do you change the crank sensor on a 2002Nissan Atima3.5?
how do you change a crankshaft position sensor on a 1999 chevy camaro z28?