you need to remove the inner door panel because there is most likely a rod that has come out of place. look for it too be hanging loose some where close to the latch or the outter handle the rod should reatach to the door handle assembly some what easilly
Inside handle, outside handle, sliding door handle?
I learned that the trick to removing the inside handle is to place a piece of cloth in the gap between the handle and cover and work it back and forth, eventually popping the clip off and sliding the handle out. It worked. You replace the clip by pushing with a flat screwdriver.
Remove the door trim panel. Remove the inside door handle rod. Remove the inside door handle retaining rivets. Remove the inside door handle from the door by sliding the handle rearward.
hold the lever. Push outside !
You will need to remove the inside door panel of your Mustang. Remove the linkage from the outside door handle. Remove the outside door handle retaining bolts. Reverse the process to install the new outside door handle.
take inside door panel off and unbolt outside door handle from the inside.
Inside door handle or outside door handle?
Remove interior door panel. Check the rod from the latch to see that is attached to the outside handle. Reattach rod. The rod clip made may need to be replaced if it doesn't hold. This condition can be caused by someone breaking in or it was serviced and not installed properly.
Need to know if it is an inside or outside door handle.
Need to know inside or outside door handle.
= outside door handle on a 1997 Toyota Camry. =
you must use a wedge on the outside above the handle to see inside and then use a coat hanger or something long to pull the handle rod