I found the display on my brothers Buick not working. i disassembled the control panel. inside there are three resistors that had bad solder joints on them and had started to burn the circuit board. i cleaned them up and soldered them. display came back on and the fan controls now work.
If u mean steering wheel controls you need a patch lead .
they just shot internaly i have a spare if you need it, wmarrs0549@yahoo.com
If the climate control is not working on a Mondeo the fuses should be checked. If the fuses are found to be working then the wiring feeds should be looked at.
all you can do is replace the climate control unit, they have them on eBay for fairly cheap
cruise control went first. then the heater controls started working one minute and then off the next. It would come on and wouldn't shut off. Then the next item that started about the same time was the headlights flashing. change the ignition switch and solved all problems.
In most cars the passenger seat has a main control also. Try using that.
Chack the speed control switch and the resistor that controls the speed of the motor
Blend door on climate control not working properlyAnswerBlend door on climate control not working properly AnswerBlend door on climate control not working properly Go to www.aircondition.com/tech regarding this problem and do the "self test" by following the steps indicated (1-6). This may correct the problem.AnswerBlend door on climate control not working properlyDo this self-test http://www.lincolnsonline.com/tech/00283.htmlIf you get error code "02" you found the problem. The part is available new online for about $35 and the dash board must be pulled to access and replace it.
i don't believe there is a reset method. is it electronic? you need to be sure that the a/c even works. it can stop working in an instant. also do the dash controls work and the doors that direct the air inside your dash. there are several things to look at.
Did the controls themselves stop working or just the lights behind the control panel? First thing would be to check the fuses that control these accessories. If the fuses are okay, I would then suspect the wiring behind the dash to have come disconnected or loose.
Check the fuses.
In this remote, the little LED light that controls the remote will emit the infra red spectrum. You will not see the light but the control will work.