answersLogoWhite

0


Best Answer

replace the filter and drain water out then at least on mine she fired right up agean after that.. water doesnot compress so if it turns over verry slow pull the glow plugs ,wind over without after draining water .because water does not cmpress at 22:1 kiss your head gasket good bye,if you don't release the pressure(via glow plugs).i would wind it 30 seconds 4or5 times{very easy to turn}

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you get a Ford F-250 7.3 liter diesel to crank after getting water in fuel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many liter of diesel need to of one liter of water?

2kv


Is one liter of water equal to one liter of diesel?

Only in volume, but not in weight.


1 liter diesel equals how many kilo?

1 liter of water weighs 1 kilo, so diesel would a bit less.


I got water in my Chevrolet 2500 diesel and now it won't crank at all what is wrong with it?

You answered your own question...you got water in it.


Where is the water separator for 6.4 liter ford diesel?

Underneath the drive side driver seat.


Where is the water separator for 6.9 liter ford diesel?

on the firewall next to the brake master cylinder


One liter diesel equal to in gram?

It's around 850 grams, which is 85% as dense as water.


Where can you find a diagram for a water pump rebuild for a 2005 GMC Sierra 3500 6.6 liter diesel?

You can find a diagram for a water pump rebuild on a 2005 GMC Sierra 3500 6.6 liter diesel in the Chilton repair manual. You can also check local auto stores.


How much doe one liter of diesel weigh in kilograms?

Well we know that one litre of water weighs 1 kilogram. Diesel is lighter than water. I would say about .85 kilograms.


Why is my 7.3 liter diesel leaking from metal tube under engine?

what fluid is leaking from the tube.is it coolant water or deisel?


Where is the crank shaft positioning sensor on a 1998 Ford Mustang with 3.8 liter?

The crank sensor is located on the bottom of the timing cover under the right hand side of the water pump by the crankshaft pulley.


What causes Milky oil in kx100 crank case?

it would be caused by getting water in the engine make sure your radiator has fluid/water . If it doesn't then your water pump is bad. Which means your getting water in the engine...